Motorola Moto E6 Charging Dock Replacement

Geschrieben von: Matthew Zelten
  • Kommentare: 3
Motorola Moto E6 Charging Dock Replacement

Schwierigkeitsgrad

Moderate

Schritte

6

Zeitaufwand

15 - 30 Minuten

Einleitung

This guide shows how to replace the charging dock on the Motorola Moto E6. It should be replaced if the device is unable to charge when plugged in or if the device is overheating while charging. Replacing the charging dock will also replace the microphone on the bottom of the phone.

  1. 5DLybpmrS5JLDGOb
    5DLybpmrS5JLDGOb
    EjyLcSxeRZN3cTRi

    • Begin by prying open the bottom right of the device using the plastic opening tool.

    • Work your way around the edge of the device, slowly prying open the casing until it pops off.

  2. NJwmxmXAKbTQ3V21

    • Use the opening tool on the divot located below the battery to pop it out.

  3. QcUnil53xwCZQStP

    • Remove the seven 3.8 mm T4 screws on the piece located below the battery compartment.

  4. ntbGhvXRLIuIeLcg

    • Begin prying off the bottom piece with the opening tools on the divot located at the bottom left.

    • Work your way around the piece until it pops off.

  5. ZPhx1n4rENQ5MbIM

    • Remove the press fit cable at the top of the charging dock with the plastic opening tool.

    • Remove the coaxial cable using the plastic opening tool.

  6. LMIxWKSXSZiyPrjX

    • Remove the two 1.1 mm T4 Torx screws on the bottom right and top left sides of the charging dock.

    • Remove the charging dock by hand.

    The white round sticker, below the top left screw on Step 6, is pink now. Do I need a new charging dock? The sticker on the battery is still white, but I plug in the charger and only a little blue light flashes on the outside top. It doesn’t hold a charge and the screen doesn’t come on anymore. It did until the phone finally died. Im just trying to find the precise problem. And thanks so much! The information and steps were very helpfully accurate.

    Megan Skates -

    Love my moto e6 phone as changing the battery is so simple. When it was clear that the charging port was causing the problem, I wasn't sure where to begin. I didn't want to buy a new phone or have someone else fix it. Was glad to find these instructions on how to change the charging port. Was a bit apprehensive as I didn't want to mess anything up. I ordered the part, but didn't realize I didn't have the correct screwdriver. Was glad to have the specific kind I needed in the instructions. Once I had the right tool following the pictures and instructions made it very easy. A couple of really close up zoomed in pictures would have been even more helpful. This included all the steps needed to replace the charging port. My new port works just fine now. Thank you!!!

    elasue -

    Thank you!! I got the part on Ebay. Had the tool that came with a replacement battery I bought a few years back for another phone and it was the right one for this. Looks like my phone is fixed. Much appreciated!

    hjwellers -

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Matthew Zelten

Mitglied seit: 23/01/20

420 Reputation

0 Kommentare