Motorola Moto Q Back Casing Replacement

Geschrieben von: Luis Herrera
  • Kommentare: 0
Motorola Moto Q Back Casing Replacement

Schwierigkeitsgrad

Easy

Schritte

4

Zeitaufwand

15 Minuten

Einleitung

This guide will show you step-by-step how to replace the back casing.

  1. AoyXuJrx1WBpZBfZ

    • Use the Push Pin to remove the rubber screw covers by pushing the needle into the rubber and pulling up.

    • Be careful not to poke yourself when handling the push pin because it is very sharp.

  2. tNDYfoiMFBQhTMfi

    • Use the T6 screwdriver to remove the four screws holding the casing together.

    • Note: they are in the same place where you removed the four rubber coverings

  3. 6BS1tNmJMn2bwMqJ
    6BS1tNmJMn2bwMqJ
    WbelrbSkk225OVd2

    • Wedge the plastic opening tool in between the top and bottom cases. This may require a little or a lot of force so be careful.

    • Note: the phone should be face up and the plastic opening tool should be face downwards

    • Once you get the plastic opening tool in, slide it across the side of the phone, making sure to keep the plastic opening tool wedged in between the two casings.

    • Repeat the 3 steps above for the top, bottom, and opposite side.

  4. BDFNHyXKyQAJNq4x
    BDFNHyXKyQAJNq4x
    sVnNnJvRTnDmuS3J

    • Gently lift and remove the back casing.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Luis Herrera

Mitglied seit: 21/01/10

52 Reputation

0 Kommentare