Nerf N-Strike Firestrike Laser Assembly Replacement

Geschrieben von: Hayes Kimball
  • Kommentare: 2
Nerf N-Strike Firestrike Laser Assembly Replacement

Schwierigkeitsgrad

Easy

Schritte

9

Zeitaufwand

15 - 30 Minuten

Einleitung

You will be able to disassemble the Firestrike and remove the laser assembly. You will need nothing other than a number 1 Phillips screwdriver and your hands. This guide can be completed anywhere and is relatively straight forward.

  1. MJUqnvxeG3sA6fU6

    • Use a #1 Phillips screwdriver to remove the 10 -mm screw that secures the battery plate, then remove the battery cover using your hands.

    This should be step 1

    Samuel Garcia -

  2. u5drJAYnRpVdHIOJ
    u5drJAYnRpVdHIOJ
    Vk4r3ZH2GgmjWS5S

    • Slide out the two AAA batteries using your fingers.

    This should be step 2

    Samuel Garcia -

  3. OkPuTeEgOsYjfyRf

    • Remove the seven 10-mm black Phillips screws from the blaster casing with a #1 Phillips Screwdriver.

  4. addsNFJ3YDd1yXYS
    addsNFJ3YDd1yXYS
    1LSJjSBuPkktTtAu

    • Slowly pull apart the blaster casing, starting at the battery location.

    • Keep pulling apart slowly until it separates completely. Be cautious as to not send the internal components flying.

  5. XOaYlWsPJYk6d61O
    XOaYlWsPJYk6d61O
    GNcEIPyStNYvIeRI

    • For reassembly, ensure that the chrome nut gets put back in the proper location, signified by the red box.

    • For reassembly, ensure that all the parts are lined up correctly on the dowels, signified by the four orange boxes.

    • For reassembly, note the location of the springs as highlighted in the second photo.

  6. JYg6M4N1qVAv3VXT
    JYg6M4N1qVAv3VXT
    yjhcBkm62dipjGnN

    • Remove the laser trigger by grabbing the trigger with your fingers and pulling it up and out.

  7. oHXuAQtwWaO3SyGa
    oHXuAQtwWaO3SyGa
    csPwThKR1fEGyi6v

    • Remove the firing trigger by grabbing the trigger with your fingers and pulling it up and out.

  8. vZ2WRXVRTrRYwFwL

    • Gently pull up on the circuit board located near the gun handle until it separates from the gun.

    • The wire that attaches to the circuit board is also attached to the laser. Be careful not to use excessive force and damage or disconnect the wire.

  9. tfkSrfordYuPntAJ
    tfkSrfordYuPntAJ
    sKdavAbCX5Y6CQVv
    qt4svrSnMmSriD4Y

    • Grip the circuit board located at the base of the laser with your fingers; rotate it towards the ammo compartment on the blaster until the guide hole is clear of the guide pin.

    • Slide the laser assembly out.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Hayes Kimball

Mitglied seit: 19/04/15

742 Reputation

0 Kommentare