Einleitung

This repair guide follows the back cover guide and requires the use of the spudger tool and Phillips screwdriver.

  1. MCho5h1hCdstl6Yn
    MCho5h1hCdstl6Yn
    IBTaglLRgGLlCHVV
    2vmefUnM2Yr34xy1
    • Remove the batteries from the battery compartment by sliding the white battery compartment switch up and then move the panel toward the right.

  2. plbg3wBXVchmOYit
    • Using the Phillips #000 screwdriver, unscrew the two 2mm screws next to the battery compartment on the right side of the camera.

  3. cjj5HS2fY2rmHOc4
    • Unscrew the two 2mm screws on the opposite side.

  4. FUFQJO2lHZ2THs3T
    • Flip over the rubber AV cover at the bottom of the camera. Unscrew the last two 2mm screws on the bottom of the camera.

  5. mbhUH4h5JtFSnguc
    mbhUH4h5JtFSnguc
    UorMuemICkqeCSJq
    LcKAfOZdXRudaqdV
    • Using your hands, open the camera slightly by using the indentation above the camera compartment.

  6. uhHpxcnXpDbqxLAx
    uhHpxcnXpDbqxLAx
    cX3vCGSNCGojQK5t
    • Wedge the flat end of the spudger in between the front and back cover. Carefully push the spudger downward, which will lift the back cover off the camera.

  7. 1CxbGF35rFYMwUmS
    • Gently pull the cover off the camera.

  8. Zi6PpYgDeVaxQilW
    Zi6PpYgDeVaxQilW
    o2itbnehQMYWbQRF
    Nvp6Q5HT4LIGLWZm
    • Carefully flip over the LCD screen onto its front. Pull the top of the LCD screen toward you keeping the bottom of it inside the camera.

    • Do not pull on the LCD screen; there is a ribbon of circuitry that is connected to the motherboard.

  9. aA4M1bkpOHTGGNmW
    • Gently hold the LCD screen down, so the ribbon lays flat against the back of the camera.

  10. SSceRssojJQhsrQX
    • Gently wedge the spudger underneath the white latch and lift the latch open.

  11. EEPc1MWG1MeHFUHA
    EEPc1MWG1MeHFUHA
    GydxpTLN4dTrkKes
    • Use the flat side of the spudger to flip the white switch on the motherboard. You should hear a light click.

  12. X4wDWxfIFtWddO6b
    • Gently pull the ribbon out of the switch.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Sadie

Mitglied seit: 16/02/15

403 Reputation

0 Kommentare