Ninja Coffee Bar® Single-Serve System Water Heater Replacement

Geschrieben von: CJ Berg
  • Kommentare: 2
Ninja Coffee Bar® Single-Serve System Water Heater Replacement

Schwierigkeitsgrad

Moderate

Schritte

10

Zeitaufwand

20 Minuten

Einleitung

If your normally piping hot cup of coffee is coming out at room temperature then the water heater may be to blame. This replacement involves removing a number of small screws so it may be a good idea to have the iFixit magnet pad nearby. Follow this guide to replace your device’s water heater and restore heat to your Ninja Coffee Bar.

  1. GeJinTkJr1LP5A1V
    GeJinTkJr1LP5A1V
    1KxAbZmZ5AJ2fSFe

    • Unscrew (8) 6mm screws using Phillips head #1 screwdriver

    • Remove bottom cover

    My Ninja has T10 Security-head screws. Several are recessed quite deep in the bottom cover. I found a set of 60mm long security torx bits on Amazon for around $12 The extended length worked great for the deep recessed screws.

    Mike Stroven -

  2. DUJTiRDYcUGkGdBa

    • Unscrew (3) 6mm screws with Phillips head #1 screwdriver

    • Remove tube protection plate

  3. fnFTZyLcHIPRoHPR

    • Detach valve tubes from valve by squeezing pins and pull tubes away from valve

  4. lMFreAIPbMehWHkM

    • Detach valve tubes from device by pinching pins and sliding the tubes off

  5. HDgH5PYCSYIpBirp
    HDgH5PYCSYIpBirp
    J1HTSFSEICwVJJPa

    • Unscrew the four 6mm #1 Phillips head screws from the underside of the basket area.

    • Remove the single 6mm #1 Phillips-head screw from the side of the unit.

  6. tC4bJFaUKigYeSad
    tC4bJFaUKigYeSad
    JCxpkCyHNwD4QgfJ

    • Slowly pry the upper cover away from the unit on top of the brew basket, and near the base of the water reservoir along the side of the upper cover.

  7. WpEusHTLUDcDVtg1

    • Separate hose from upper nozzle by squeezing the clamp and pulling the hose down slightly.

  8. RHQpygAFSdPFaRAX
    RHQpygAFSdPFaRAX
    LYktKLiQVcAOFtBp

    • Using a #1 Phillips head screwdriver with an extension, remove three 6mm screws holding the heater to the unit.

  9. cIGYoqHYODbi6Ioa

    • Remove heater from unit.

  10. XMEmXXQKeVvWCyuI
    XMEmXXQKeVvWCyuI
    WGkfw3MNhZrKRoXc

    • Squeeze clip and separate signal wiring.

    • Using wire stripper/crimping tool, uncrimp wiring connectors

    • Wiring connectors are sealed together making them difficult to disconnect. Cutting and rewiring should be considered.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

CJ Berg

Mitglied seit: 05/11/18

444 Reputation

Ein Kommentar

Where can I buy the water heater?

lrstorey1 -