Einleitung

  1. pueJPNL3ruoRnBhS
    • Slide the back cover down with your thumb.

    • *Note: the battery cover is not shown in this picture

  2. 3yuFXuHK2pERNmvm
    3yuFXuHK2pERNmvm
    vwaHTxtqMEWflSmm
    • Gently lift the battery with a fingernail and remove it from its housing.

    • *Note: the battery may be replaced or repaired at this step

  3. vUAohEYGWUjXbkvY
    vUAohEYGWUjXbkvY
    bDeVcaWFrZfSUXAE
    6PTUjTa15utAhgNA
    • On some models, the front case is screwed down from the back. Follow steps 5 and 6 FIRST to remove the camera cover and two T6 screws, before removing the faceplate.

    • Use the Spudger to gently pry up the edges of the front face plate

    • At the center of the faceplate edge below the music keys there is a small latch on each side.

    Before doing this step, first remove the camera cover and the two t6 screws from the back (steps 5 and 6). Otherwise you will break the cover. This may be a factor only for some revisions (RM-304)

    s c -

  4. JwCAIHBbmTPHNJma
    JwCAIHBbmTPHNJma
    eBI6WHukRPW2Njij
    • Lift up the keypad from the bottom with either the spudger or your finger.

    • Note: at this time the keypad can be removed and replaced

  5. W4ktbYXrSAJiAWmu
    • Gently unsnap the back camera cover from the phone.

    • Lift the cover from the phone after it is unsnapped.

  6. vmcoyRqZSBWFNIJb
    vmcoyRqZSBWFNIJb
    KNVkJE24uFtoKbuR
    • Use the T6 torx screwdriver head to remove the 2 screws on either side of the camera

    • Flip over the phone and again us the T6 torx head to remove the 4 screws located at each corner of the white keypad base

  7. FSgmQ4mrBHVmygWh
    • Unclip the faceplate plug (ribbon) located in the lower left corner of the motherboard

  8. nKTglgXXDKvsT5Ap
    nKTglgXXDKvsT5Ap
    BpKWNQNtVtQREsuS
    • Use the Spudger to pry up the 2 metal clips located near the center of the motherboard on both the left and right

    • At this point the phone should come apart into 2 pieces, the motherboard/LCD screen and the faceplate

  9. fCCfQxKLs2NxXQV6
    • Unclip the ribbon plug located on the top of the LCD screen that connects it to the motherboard

Abschluss

To reassemble your device, follow these instructions in reverse order.

Max Kirby

Mitglied seit: 01/05/11

518 Reputation

Ein Kommentar

Thank you much! As efficient & thorough as it gets!

REDACTED FREE PRESS -