Einleitung

  1. pueJPNL3ruoRnBhS
    • Slide the back cover down with your thumb.

    • *Note: the battery cover is not shown in this picture

  2. 3yuFXuHK2pERNmvm
    3yuFXuHK2pERNmvm
    vwaHTxtqMEWflSmm
    • Gently lift the battery with a fingernail and remove it from its housing.

    • *Note: the battery may be replaced or repaired at this step

  3. vUAohEYGWUjXbkvY
    vUAohEYGWUjXbkvY
    bDeVcaWFrZfSUXAE
    6PTUjTa15utAhgNA
    • On some models, the front case is screwed down from the back. Follow steps 5 and 6 FIRST to remove the camera cover and two T6 screws, before removing the faceplate.

    • Use the Spudger to gently pry up the edges of the front face plate

    • At the center of the faceplate edge below the music keys there is a small latch on each side.

    Before doing this step, first remove the camera cover and the two t6 screws from the back (steps 5 and 6). Otherwise you will break the cover. This may be a factor only for some revisions (RM-304)

    s c -

  4. JwCAIHBbmTPHNJma
    JwCAIHBbmTPHNJma
    eBI6WHukRPW2Njij
    • Lift up the keypad from the bottom with either the spudger or your finger.

    • Note: at this time the keypad can be removed and replaced

  5. W4ktbYXrSAJiAWmu
    • Gently unsnap the back camera cover from the phone.

    • Lift the cover from the phone after it is unsnapped.

  6. vmcoyRqZSBWFNIJb
    vmcoyRqZSBWFNIJb
    KNVkJE24uFtoKbuR
    • Use the T6 torx screwdriver head to remove the 2 screws on either side of the camera

    • Flip over the phone and again us the T6 torx head to remove the 4 screws located at each corner of the white keypad base

  7. FSgmQ4mrBHVmygWh
    • Unclip the faceplate plug (ribbon) located in the lower left corner of the motherboard

  8. nKTglgXXDKvsT5Ap
    nKTglgXXDKvsT5Ap
    BpKWNQNtVtQREsuS
    • Use the Spudger to pry up the 2 metal clips located near the center of the motherboard on both the left and right

    • At this point the phone should come apart into 2 pieces, the motherboard/LCD screen and the faceplate

Abschluss

To reassemble your device, follow these instructions in reverse order.

Max Kirby

Mitglied seit: 01/05/11

518 Reputation

Ein Kommentar

Step 5 and 6 must be performed before step 3, otherwise, you will dislodge the thread from the front plate. so you have to remove the camera cover first, remove the 2 screws then you can remove the front plate without breaking anything.

Vincent Tschanz -