Nvidia Shield Tablet K1 WIFI Antenna Replacement

Geschrieben von: James Upchurch
  • Kommentare: 5
Nvidia Shield Tablet K1 WIFI Antenna Replacement

Schwierigkeitsgrad

Moderate

Schritte

6

Zeitaufwand

30 Sekunden

Einleitung

  1. 61fMRxSK2R4sTQo3

    • Starting at the Micro SD Card Slot and using the blue plastic opening tool, begin to maneuver the tool around the edges while applying light pressure to lift the panel upwards.

  2. nfuWrRUCLRrxCel5
    nfuWrRUCLRrxCel5
    CxCBNQHdHWjc2LFN

    • There are clips holding the back panel to the rest of the case. You must apply some force to lift the back panel off.

    • Continue lifting up the panel all the way around the edges of the tablet.

    • Once all of the panel clips are unfastened, gently remove the back panel.

  3. 5GB3FM6FwqFojhp5

    • Use the angled tweezers to disconnect the black power cable from the mother board. The Cable should pop up from its slot when pulled.

    • Make sure you disconnect the right cables. There are three of these.

    You do not need to disconnect the antenna power cable. You only need to disconnect the other 2 black power cables. Just pull the antenna out together with the Mboard.

    Dave Bogan -

    Did you not remove the battery and disoldered its cables? Why are they still in place?

    Nikos Tsarmpopoulos -

  4. OIuAyGOo1UjgkAmx

    • Remove the screw adjacent to the WIFI Antenna using the J000 Philips head screw-driver.

    • Screw description: short black screw 20 mm length and 30 mm diameter.

  5. 3F3Sp2MGcPg3YdMi

    • Using the angled tweezers, begin removing the antenna from the device.

    You only need to free the antenna from the case. Leave it hanging from the Mboard.

    Dave Bogan -

  6. VCZQZVZpRAGgDorK
    VCZQZVZpRAGgDorK
    2oXxsNOd6eYhBKSs

    • The black plastic piece of the antenna is attached to a copper colored film which can be pulled up using the tweezers.

    • The antenna should now be free from the device.

    what replacement part can i use?

    just -

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

James Upchurch

Mitglied seit: 10/02/16

646 Reputation

Ein Kommentar

Odd question for you. I'm replacing the antena in a nvidia shield as an experimant, as was wonder if you know what type of connecter is used on the cable to the pcb. I dont want to desoder the exsisting antenna if i can help it as they are calabrated.

Justin Mosimann -