Einleitung

Der Akku befindet sich hinter der gläsernen Rückabdeckung. Hier wird der Austausch des Akkus gezeigt.

  1. h5ynssrkDIBplqRh
    h5ynssrkDIBplqRh
    YKMQVLJXCqIuPSJQ
    • Schalte das Smartphone an der Einschalttaste aus. Das ist die kleinere der Tasten an der rechten Seite.

    • Halte die Taste einige Sekunden gedrückt, bis die Option "Ausschalten" erscheint.

    • Tippe darauf und das Smartphone fährt herunter.

  2. L2e5qBKbogbIsUd4
    L2e5qBKbogbIsUd4
    e1IwERvEbMF4kmKF
    KNwuu4XIgVyKg1wP
    • Setze ein Werkzeug zum Entfernen der SIM Karte in das kleine Loch oben rechts am Smartphone ein, über den Tasten der Lautstärkeregelung.

    • Wenn du nicht das Originalwerkzeug hast, kannst du eine aufgebogene Büroklammer benutzen.

    • Drücke das Werkzeug ein, der Einschub sollte herausspringen.

    • Entferne den Einschub vom Gerät.

    There is absolutely no reason to remove the sim tray, we're not removing the motherboard.

    Dennis Meerveld -

    You could at least save your SIM cards (and uSD card) some of the unnecessary heat treatment that way.

    S K -

  3. SYaDa1iqd2QjvDVL
    SYaDa1iqd2QjvDVL
    Y1hfpUJeNAN6muGo
    sPJPHMo2QQbPqIa2
    • Ziehe Handschuhe gegen die Wärme an und lege das Smartphone auf eine hitzeunempfindliche Oberfläche.

    • Erwärme die Rückabdeckung langsam und gleichmäßig mit einem Heißluftgebläse.

    • Verweile dabei nicht zu lange an einer Stelle. Zu viel Hitze an einem Punkt kann das Gerät beschädigen.

    • Während du die Rückseite erwärmst, kannst du mit einem Jimmy testen, ob der Kleber schon weich genug ist, dass er sich ablösen lässt.

    • Löse vorsichtig die Rückabdeckung ab. Benutze Plektren um die Teile getrennt zu halten.

    • Wenn die Kanten genügend aus der Klebeverbindung befreit sind, musst du einen Saugnapf auf der Glasscheibe anbringen.

  4. xFJXCTP4OmExHHDQ
    xFJXCTP4OmExHHDQ
    GJxEsbXs2Q1nc5E4
    gUBkCDuyaddfrrf3
    • Drücke den Saugnapf an der Scheibe an, bis er gut festsitzt.

    • Ziehe mit Hilfe des Saugnapfs die Rückabdeckung vom Gerät ab.

    • Der Saugnapf hilft dir beim Ablösen der Abdeckung. Passe dabei auf, dass sie sich durch die vorhandene Restwärme nicht wieder verklebt.

    It can't be stressed enough to do this very carefully. I did it very carefully, but not carefully enough. Cracked a corner. Also not just the edges, there's extra adhesive on the lower 2-3 cm's of the back.

    Another remark, get in between the black bezel and the back cover, this is a bit unclear on the first picture. Same goes for the front, get in between the bezel and the front assembly.

    Dennis Meerveld -

    Most of the adhesive is on the top and bottom ends, yes.

    I would recommend one to steer clear of the camera assembly though (the LED lens is plastic and melts) + the center (where the battery is, mine swelled a bit).

    S K -

  5. DWbKZI4ntppac4P2
    DWbKZI4ntppac4P2
    oxXkYDUU3yQWaoLb
    gFI55jsX3Z5ZrlaI
    • Drehe folgende sieben Kreuzschlitzschrauben #000 heraus:

    • Vier längere Schrauben

    • Drei kürzere Schrauben

    • Wenn die Schrauben alle weg sind kannst du die Metallabdeckung mit einem Spudger hochhebeln.

    • Sie ist mit zwei Laschen unten direkt über dem Akku befestigt, beginne also an der Unterseite.

    What size of screw goes where?

    Will -

    Check http://imgur.com/wqD9Dis. Orange circles are the smaller screws (3 out of 7 are smaller than the other 4).

    Dennis Meerveld -

  6. uqBG3p4pVuLVS1Nw
    uqBG3p4pVuLVS1Nw
    MdPFnJIrgCjPreRA
    • Wenn du die Abdeckung abgenommen hast kannst du den Verbinder des Akkukabels auf der Hauptplatine sehen.

    • Löse den Verbinder vorsichtig mit einem Spudger.

    • Dadurch wird die Stromversorgung abgetrennt. Das ist wichtig, damit kein Bauteil während der Reparatur unter Spannung steht.

  7. 6JMGGr6ExXkbNIOT
    6JMGGr6ExXkbNIOT
    Kpy6q4E4EsgbhNKU
    XjIb5Qpc1XySMZYb
    • Finde am Akku eine aufgeklebte durchsichtige Zuglasche.

    • Fasse die Lasche fest an und ziehe sie hoch, weg vom Smartphone.

    • Lasse dir dabei Zeit. Wende nicht zuviel Kraft auf und beschädige nicht den Akku.

    • Der Akku ist auf der Unterseite festgeklebt. Es ist also hilfreich, wenn du den Spudger zwischen Akku und Gerät einsetzst, um die Klebeverbindung aufzutrennen.

    • Ziehe so lange am Akku, bis er ganz frei ist.

    Strictly speaking, you don't need to remove the battery at all. The connector to the front assembly is underneath the speaker assembly.

    Dennis Meerveld -

    If your order the complete part you need to remove it.

    The battery is glued in very well and it bends pretty easy. It is wise to order a new battery aswell.

    Chris S. -

    I agree it's nearly impossible to remove the battery without damaging it. Even a tiny little bending can lower the capacity. And if you heat it up too much to soften the glue it can explode. Also never use metal tools on the battery in case u break through the protection foil it won't catch fire.

    Peerless Records -

    The instructions on the pull tab itself are pretty clear and contradict what's said here!

    "Tear from position 1, and then pull out the battery from position 2."


    The battery sits in a kind of a black "vest", which is the thing glued to the phone (not the battery itself).

    This vest can be "unbuttoned" from the top and bottom sides (position 1, visible on some of the previous pictures).

    After that the battery would pop out with much less effort (there is some adhesive in the "vest", but it's much less robust).


    What is being depicted here is quite dangerous and unnecessary, as it makes the battery bend heavily.

    S K -

Abschluss

Um dein Gerät wieder zusammenzusetzen, folge den Schritten in umgekehrter Reihenfolge.

Luis Castro

Mitglied seit: 08/02/16

2061 Reputation

8 Kommentare

Thanks! This is cool! I didn't know I can replace my OnePlus X's battery :)

Antonius Harijanto -

how to stick back panel to the device again?

Sarthak Ahir -

Double sided adhesive

Maxime LUCAS -

Does someone know a good vendor for a new Battery for the OPX that sells in europ? I also want to change the battery after 2 1/2 years.

Thanks in advance =)

Det Maat -

Hi

++https://www.ebay.de/itm/382548678130++ —-any good ?

My original battery runs low., have to do something. Love the phone still….

Api K -

really good, in this world still there are helpful people. Great, thanks

Manan Dalal -

It is extremely hard to open back cover.

Adhesive won’t go soft enough

Any advice please.

Mat

Mateusz B -