Oregon Scientific Meep! X2 Cameras Replacement

Geschrieben von: J'mel Henneman
  • Kommentare: 0
Oregon Scientific Meep! X2 Cameras Replacement

Schwierigkeitsgrad

Moderate

Schritte

6

Zeitaufwand

15 Minuten

Einleitung

Follow this guide in order to fix the cameras in your Oregon Scientific Meep! X2 tablet.

  1. YLWlCTuGRDDQPWWN

    • Remove the orange covers from the left and right sides of the device by sliding up against the tabs.

  2. EKTkeNRLYujVD2lH
    EKTkeNRLYujVD2lH
    UNTb4RTP6ibquJ1q
    OINbQV1bQRDHKaBt

    • You can remove the rear casing by unscrewing all six phillips #00(3.5mm x 4.5mm)screws from the left and right side of the device.

  3. xspdyCQPa2kikpSH
    xspdyCQPa2kikpSH
    t6PXiSJbibeAiCfR
    TJZTOaOhPP4uv2iy

    • Use the plastic opening tools to undo the clips around the edges of the device.

  4. LFvS1q5WHeZL2aFx
    LFvS1q5WHeZL2aFx
    XwrOWYOutphUMQNs

    • Slip the plastic opening tool under the white, square enclosure of the camera and lift upward to unhook the camera unit from the motherboard.

  5. cEaWEWyODBHYdlrR
    cEaWEWyODBHYdlrR
    NCUOGfdoDjJVyb2V

    • Pry the second camera out of its slot with one of the plastic opening tools.

    • Be sure to undo the black adhesive foam from the metal casing in order to remove the camera properly.

  6. T2NabQFEqLYS4CFs

    • Release the black security clip on the ribbon cable with your plastic opening tool.

    • Gently disconnect the gold ribbon cable from the motherboard. The two cameras will remain attached to the ribbon cable.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

J'mel Henneman

Mitglied seit: 20/01/15

864 Reputation

0 Kommentare