PSP 300x Casing Replacement

Geschrieben von: kbrunner
  • Kommentare: 5
PSP 300x Casing Replacement

Schwierigkeitsgrad

Moderate

Schritte

6

Zeitaufwand

5 Minuten

Einleitung

Steps for replacing the outer casing of a Sony PSP-3000.

  1. TrUmfMIuTdKnA1Cn
    TrUmfMIuTdKnA1Cn
    yJW4ra1RPAwB3mYP
    EGjqqfqlRcpevFHa

    • Place the PSP face down and locate the battery cover on the left side of the device.

    • Lift and remove the battery cover to reveal the battery.

    • Remove the battery.

  2. WwNswCUCuutjhWcd

    • Peel back the warranty sticker that is behind the battery with a spudger or your fingernail.

    This will end your warranty, so do it on your own risk!

    Paweł Kasztura -

    Even though warranties are long expired on these things.

    Vincent C. -

    “IF” your on this Site “I FIX IT(tm) to lean how to repair something on your own… you “Should NOT” be too concerned about warranty any longer, as if you were .. for your iPhone or Pad etc… you would have taken it to the supplier.. No??

    Barry Goian -

  3. 2jvKwbGyeHYdH5m1
    2jvKwbGyeHYdH5m1
    FJxVn2bSqXKi5LsX

    • Unscrew all four screws from the back of the PSP with the Phillips #00 Screwdriver.

    • Two are located behind the battery's warranty sticker.

    • Two are located on the right side of the PSP.

  4. FwFsxefOstRBZYIX

    • Next, unscrew the two screws located at the top of the PSP.

  5. nfaMmtCKKxRYKXNX

    • Then, remove the single screw from the bottom edge of the PSP (which is positioned next to the barcode).

    “DON’T” forget to put your screws separately on a mag mat (Or sticky tape) so to 1) Not loose them & 2) Remember where they go as they may be of differing sizes. (Refer time the pictures also helps, but you can take a pic on your camera as you go to remind you also.

    Barry Goian -

  6. GTBGyfJfojtdYbvv
    GTBGyfJfojtdYbvv
    kKwEelLMbuDXtkYh

    • Slide the spudger in between the outer casing of the PSP, beginning at the "R" shoulder button, and gently pry off the casing.


    • Remove the front casing completely.

    J’ai récemment fait cette réparation et le boîtier avant ne voulait pas venir à condition d’enlever les deux vis sur le boîtier arrière au niveau du joystick et de la croix directionnelle. Il manque donc selon moi une partie mais je peux me tromper !

    Valentin Boileau -

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

kbrunner

Mitglied seit: 05/11/09

60 Reputation

0 Kommentare