Palm Pre Antenna Replacement

Geschrieben von: noha
  • Kommentare: 0
Palm Pre Antenna Replacement

Schwierigkeitsgrad

Difficult

Schritte

6

Zeitaufwand

30 Minuten

Einleitung

  1. ReDOJjQgRrbXBeub

    • Make sure your Palm Pre is turned off before disassembling the phone.

    • Snap off the back panel to reveal the battery.

  2. 2dmd3tdY4jEZEeqa

    • Carefully pull up on the tab to remove the current battery.

  3. KtHDSLhWOWWwhwaL
    KtHDSLhWOWWwhwaL
    LfL1FLFmgFunDmiV

    • Use the T5 Torx Screwdriver to remove the six screws holding the backing frame in place.

  4. VNmEyJJR4LuierZr

    • Locate the hinge that covers the black and white GPS and DIV antennas. (The hinge will be located in the red box as portrayed in the picture.)

    • Use a spudger to pry open the hinge.

    • Use tweezers to disconnect the antennas from the keypad control board.

  5. UVHXQNUsdZttovWS
    UVHXQNUsdZttovWS
    4VWUXAx6DdYt1mJk

    • Use a spudger to pry off the (black and yellow) back frame.

    • Disregard the main part of the phone at this point and look only at the inside of the removed back frame. (You will need the main part of the phone for access to the keyboard and motherboard)

  6. yi61lylmVTECgeND

    • Find the small circuit board at the top right and desolder the wires that are connected to it.

    • This step is only necessary for antenna removal.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

noha

Mitglied seit: 12/04/12

139 Reputation

0 Kommentare