Palm TX Back Panel Replacement

Geschrieben von: Spencer Lewson
  • Kommentare: 0
Palm TX Back Panel Replacement

Schwierigkeitsgrad

Moderate

Schritte

5

Zeitaufwand

5 - 8 Minuten

Einleitung

Removing the back panel allows you to access the various parts of the Palm T|X PDA.

  1. SFqUJpIxgUDWqMDg
    SFqUJpIxgUDWqMDg
    eScJPtslX1VtsP5Z

    • Orient the device so that the display faces forward.

    • Remove the stylus from the right side.

  2. cU3agxDMnT5RnWAM

    • Turn over the device so that the back panel faces forward.

    • Use a T5 Torx screwdriver to remove the four 6.35mm corner screws.

  3. xfoRukNaUfI1RLXB
    xfoRukNaUfI1RLXB
    K2hSQNYTu2BmokBO

    • Rotate the device so that the display faces forward.

    • Insert a plastic opening tool with the angled tip pointing downward into the crevice on the left side of the device.

    • Pry along the crevice to loosen the back panel.

    • Repeat this process for the right side.

  4. RVnJ6LRyWDeAW2Bq
    RVnJ6LRyWDeAW2Bq
    adjBVeEfOplaNhMp

    • Carefully pry the back panel to open the device.

    • Be careful not to break the wire that connects the battery pack to the motherboard.

    • When reassembling, snap the back panel back into place and then insert the top cover.

  5. mKT1vZ2xqFrEwSUs
    mKT1vZ2xqFrEwSUs
    RByTDfhlQgNr6HNZ

    • Use a plastic opening tool to peel the battery pack from the back panel.

    • The battery pack is glued to the back panel so removing it may require considerable effort.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Spencer Lewson

Mitglied seit: 19/01/11

778 Reputation

0 Kommentare