Palm Treo 680 Back Panel Replacement

Geschrieben von: Maiya123

Schwierigkeitsgrad

Moderate

Schritte

Zeitaufwand

15 - 20 Minuten

Einleitung

This guide shows you how to take off the back panel to the Palm Treo 680 in order to reach the other components within side the phone.

Remove the battery cover by pressing on the small rectangular button located on the back of the phone.

Donde puedo comprar un telefono palm

Meurge porfabor

Use a T5 Torx screwdriver instead of a T6. T6 is too big.

I found T5 too large as well. T4 seeems to work

Using the spudger, remove the rubber rectangular cover located in the upper rear, right-hand corner.
Remove the 27mm screw using the T6 Torx screwdriver.
If there is a red Palm sticker covering this screw, puncture it to access the screw.

Turn the phone so the screen is facing the right side.
Use a spudger to carefully separate the back panel from the front panel to access components inside the phone.
Separate the covers from the left side of the device as indicated in the picture.
The right side contains orange ribbons that are easily damaged.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Mitglied seit: 23/10/09

51 Reputation