PalmOne Zire 72 Control Pad Replacement

Geschrieben von: Michelle Medina
  • Kommentare: 0
PalmOne Zire 72 Control Pad Replacement

Schwierigkeitsgrad

Moderate

Schritte

8

Zeitaufwand

Keine Schätzung

Einleitung

  1. kiBbVdFkkvIqZwEM
    kiBbVdFkkvIqZwEM
    NpaV1SxR2pkdTsLr

    • Using a T5 Torx screwdriver, unscrew the two 5mm screws located at the bottom of the device.

  2. QDja3llUOwyDcTE1

    • Peel back the adhesive label below the camera on the rear to reveal a hidden screw, circled in the picture to the left.

    • If you peel the entire adhesive off, two holes underneath will be exposed to future damage. Try to preserve the label to reapply later.

    • Alternate Procedure: Underneath the camera, feel for a depression and cut the sticker directly above the depression to reveal the hidden screw.

  3. YBjqUUkAl2NfDjtI

    • Use a #00 Philips screwdriver to remove the 2.5mm hidden screw.

  4. 1XLHLohejfwJbNCF

    • Use either end of the spudger to carefully pry off the camera lens mesh cover.

  5. EoNUvK2PXlNcv2lJ

    • Using the #00 Phillips screwdriver, remove the two 9mm screws on the top corners of the device.

  6. coWFFROc22hewPuk
    coWFFROc22hewPuk
    LT5xTMOMALesfXtM

    • Spin the phone around so that the headphone jack is facing you. Run the flat end of the spudger around the entire edge of the device to gently pry the case off.

    • Gently remove the case to avoid damaging it. Do not try to force the case open.

    • The L shaped latches located on the bottom of the device make it hard to remove the case; you should run the spudger around the device's edges again if you are having problems.

  7. ohxsZHD3iWRg5I3N
    ohxsZHD3iWRg5I3N
    MghKdiPTMVLI6GWW

    • Remove the cover by lifting it from right to left.

    • This should be similar to the action of the opening of a book.

    • The brown film connecting the motherboard to the screen may tear if this is not done carefully.

  8. TqAVFwjESOaWmIXS

    • Lift the control pad buttons off of the motherboard.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Michelle Medina

Mitglied seit: 11/04/12

63 Reputation

0 Kommentare