Petnet SmartFeeder SF10E Battery Replacement

Geschrieben von: Kristin Villanueva
  • Kommentare: 0
Petnet SmartFeeder SF10E Battery Replacement

Schwierigkeitsgrad

Moderate

Schritte

5

Zeitaufwand

10 Minuten

Einleitung

Use this guide to replace the battery for your SmartFeeder to get your device up and running again. This guide is also a prerequisite to access and replace the motherboard and charging assembly.

  1. ZZyUJhfVIRHwYqGb
    ZZyUJhfVIRHwYqGb
    ITGAjlR5uv2nCVM1
    NBb3b3iOECyRAmEf

    • Eject the SmartBowl by pressing the button located at the front of the SmartFeeder base.

    • Remove the metal tray by using both hands and pulling out the bowl towards you.

  2. R4r2s3yBSrkF2nf6
    R4r2s3yBSrkF2nf6
    CAgXQ1AyIsln5Ynr

    • Turn the bowl tray side down by using both hands.

    • Remove seven 11 mm screws by using the Phillips #1 screwdriver.

  3. 21UkrQu1BIq6rups
    21UkrQu1BIq6rups
    U1CxL6YuDGfcRBhN

    • Take the battery out of the SmartBowl with tweezers, avoid pulling on any wires.

    • Hold the SmartBowl down using one hand while using the other hand to remove the battery.

  4. XGGyOdZMgXHg2xWh
    XGGyOdZMgXHg2xWh
    GA3RHYZBxs35aEEm

    • Remove the tape, closest to the four white connectors, with your hands.

    • Keep the wires attached to the tape for easy reassembly.

  5. DlK4MBPsjEIolPMo
    DlK4MBPsjEIolPMo
    H1hTDu11X4KfcOZQ

    • Trace the wires with your hands from the battery to the motherboard.

    • Detach the three-prong connector between the battery and the motherboard by pulling the white connectors with your hands.

    • Hold on to the sockets on the motherboard or you could accidentally pull off the entire assembly.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Kristin Villanueva

Mitglied seit: 08/10/18

370 Reputation

0 Kommentare