Philips DC320 37 Bottom Button Circuit Board Replacement

Geschrieben von: Greg Lane
  • Kommentare: 1
Philips DC320 37 Bottom Button Circuit Board Replacement

Schwierigkeitsgrad

Easy

Schritte

6

Zeitaufwand

15 Minuten

Einleitung

Follow the procedure outlined in this guide to remove and install the circuit board for the device's bottom buttons.

  1. UHgWuSjPUcqaBAAP

    • Pry off the four white feet with the pointed end of the spudger

  2. V21CawLi2fTRLHrQ

    • Unscrew the four 15.5 mm Phillips #2 screws that hold the bottom panel to the dock.

  3. EVAJNaADthnDRWtk

    • Use the flat end of the spudger to pry the lid off from the two connectors holding it to the body of the dock.

    • The connectors on the panel are fragile and may break.

  4. AC4yGkktpFkIrau5
    AC4yGkktpFkIrau5
    4OAFMGFY6edvpdQ6
    CTAQrEGNPjMJkIUY

    • Carefully pull up and out the four electrical connectors and the two ribbon connectors connecting the bottom panel and the dock.

    • Electrical Connectors

    • Ribbon Connectors

    • The cables do not have a lot of slack in them. Be careful not to break the connectors.

    • One wire is soldered onto the bottom panel. Be careful not to break this bond.

  5. WuAUqhCMGRaVF6nL

    • Unscrew the ten 6 mm Phillips #00 screws holding the board in place.

  6. OC432qtaFUpUN13I

    • Pull the board out from the dock

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Greg Lane

Mitglied seit: 16/04/13

9 Reputation

Ein Kommentar

My philips dc 320 /37 A do not sown time digits and frecvency digits . Where can I find schematic diagram?

Thank you

chioreangheorghe -