Philips Norelco MultiGroom 3100 Casing Replacement

Geschrieben von: ahaharevolution
  • Kommentare: 5
Philips Norelco MultiGroom 3100 Casing Replacement

Schwierigkeitsgrad

Moderate

Schritte

6

Zeitaufwand

5 - 10 Minuten

Einleitung

This guide will show you how to remove the casing in order to access the battery and motor.

  1. 2tskTqSQdSquUDRs

    • Remove the comb from the top of the trimmer.

    Nina Lovekrist, Katie Scalion and Martin CREATED THE POWER BUTTON GUIDE. The recent modifications asa far as Team Members by Adam are FALSE. WE WERE TEAM 1- LEAHY 2015 USF

    *SO GIVE CREDIT WHERE CREDIT IS DUE & STOP ERASING NAMES.

    Nina Lovekrist -

  2. KtwNLBjj21YZgKRq
    KtwNLBjj21YZgKRq
    TPhcxFXDe5BFrwbH

    • Grip the attachment and twist it counterclockwise until you hear a click.

    • Pull the attachment up to remove it from the trimmer.

  3. duhBhM5EgNCttruc
    duhBhM5EgNCttruc
    ikNNdsPf4XZY5Jsv

    • Hold the trimmer upright so it is facing you.

    • Insert the plastic opening tool in the gap at the top of the power button.

  4. IexDLKtTuPpCEMoy

    • Apply pressure to pry off the power button.

  5. d5UITVC1pZ2RdqMR
    d5UITVC1pZ2RdqMR
    iqWP45tTKTyNZKUj

    • Insert the spudger into the bottom of the gray bezel and begin to gently pry it off.

    • Separate the bezel one clip at a time so that the clips do not break.

    Works better if you use the thin opening picks all around the edge at once.

    Patrick Wang-Freninger -

  6. PZblbqCJhUQdnphN
    PZblbqCJhUQdnphN
    NT5ikJNnNaBZAZir

    • Insert the spudger in the indicated hole and apply a tilting force to loosen the outer casing.

    • Pull upward on the top of the inner housing to remove it from the outer casing.

    This has to be a hard spudger that does not bend. The one on the picture is not included in the ifixit Pro Tech Toolkit, so I used a small screwdriver.

    Patrick Wang-Freninger -

    Applying force on the top of the outer case as in the second image didn’t work very well for me. But the outer case has a hole where the charger terminals exit the bottom of the shaver. I was able to remove the inner housing by holding the outer case and pushing in on the recessed plastic surface around the terminals with a small screwdriver. On reassembly, the housing snaps right back in.

    Jakob C -

    I snapped a plastic spudger trying this Step 6. I found an easier way, was to simply flip the shaver to the other side, use your thumbs to push upwards the inner unit from the outer unit. There is no bracket or clip that is actually holding it together that you must manipulate with a tool. Thanks for the writeup.

    Jogill -

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

ahaharevolution

Mitglied seit: 05/10/15

759 Reputation

0 Kommentare