Einleitung

  1. eufRGYoXErBNHWjm
    eufRGYoXErBNHWjm
    cNZ6qmnLYCjVYjol
    bKWCXIbvZlTITdn1
    • Lay the player flat so the bottom outside is showing. Using the Phillips #0 screwdriver, unscrew all the housing screws on the bottom of the player.

    • Have the player sitting upright, remove the rubber stoppers in order to get to the screw. Unscrew the inside screws by the screen using the Philips #0 screwdriver.

    • Remove the rubber stoppers for the bottom two screws as well. Unscrew the middle two screws.

    Can you provide one for the bad motor and how to fix the problem. Please, email me at syaiugligs@gmail.com when you have the guidelines available.

    Thank you!

    Sylvester Yaiuglig -

    The screws on the top of the screen and bottom are not necessary

    grace nicosin -

  2. HotaE4PLGBMl4AjJ
    HotaE4PLGBMl4AjJ
    lBRUPhTgQD1hnyMT
    • Open the disc flap and remove the screws inside with the Phillips #0 screwdriver. There will be three screws.

  3. LLmSbDtrlaBYYMYY
    LLmSbDtrlaBYYMYY
    qAooPi6JoDRgFi43
    cseMW2Owa6GHQqRE
    • Start removing the inside black face plate of the player by using a prying method between the white outer housing and the black face plate with a metal spudger.

    • Pull the black face plate off once you have pried it from the white housing. The bottom inside layer should pop off.

    • Using the same prying method with the metal spudger, start prying off the screens white outer housing.

  4. QPF1kvcBLj4ir2rE
    QPF1kvcBLj4ir2rE
    Dq4RwyjxyWcPXGsY
    HXGrtJaxuOWKhn3j
    • The light panel on the front can just pop right off.

    • To remove the metal bar against the battery, unscrew the screws with the phillips #0 screwdriver.

    • After unscrewing you can just lift the metal bar off.

  5. tKapXJkKDBQKwN1K
    • Desolder the wires connected to the round speakers.

  6. KqPXKSjKHGOkvvlF
    KqPXKSjKHGOkvvlF
    m5kJGGNlnHBZNHHG
    • Place the iOpener over the entire speaker panel to warm the glue.

  7. ThnrUrW54uYCNaEY
    • After the glue is softened, use the metal spudger to scrape the glue away.

    • You may need to use the iOpener more than once per speaker, but be sure to follow the instructions for the iOpener so as not to overheat it.

  8. 5V2XKsduglNxqXkH
    • Use the spudger to pry the speaker out of it's setting.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Alecia Franklin

Mitglied seit: 28/09/15

179 Reputation

0 Kommentare