PlayStation 2 Slimline SCPH-7500x IR Sensor Replacement

Geschrieben von: Jared Hirata
  • Kommentare: 2
PlayStation 2 Slimline SCPH-7500x IR Sensor Replacement

Schwierigkeitsgrad

Easy

Schritte

8

Zeitaufwand

10 Minuten

Einleitung

This guide will walk you through step-by-step on how to properly remove and install the IR sensor in the PlayStation 2 Slimline.

    • Turn off the PlayStation 2 and carefully unplug it from the power source. Also, it is important to eject the CD from the console before flipping the it upside down.

  2. rrxNCIoAMHJAQYbe

    • Locate the six feet on the bottom of the PS2.

    • Five of these feet are in plain sight while the last foot is located under the black void sticker on the back of the device.

    • Some versions of the console, such as the PAL Version, may not have this sticker. In this case, the foot or the screw should be in plain sight.

  3. XQThRiIVRdtfUQao
    XQThRiIVRdtfUQao
    CePSemaKYMndK2lE
    xRGCV3jyVnRXsExG

    • Remove the five visible feet from the bottom of the device using a spudger.

  4. TyDcmOhovTXCtDUV
    TyDcmOhovTXCtDUV
    3FwDx6oGEXcqdp5D

    • Remove the sticker and then remove the 6th foot.

  5. VSZUQRQLZhPX3K3r
    VSZUQRQLZhPX3K3r
    IqZSVQMBAt61xeun
    FS61tBC1AeuAIULo

    • After all of the feet have been removed, Use a Phillips #1 screwdriver to remove the six 4.0mm screws from the base of the PS2.

  6. yKUm3LR1HlJljbpB
    yKUm3LR1HlJljbpB
    ANm1oOasZFjwWdIy
    aTKEotTNmoZOBNdi

    • Once all of the screws have been removed, pry apart the plastic covers. Start by lifting the side containing the power cable and Ethernet port. Then, lift the opposite side to fully separate the two sides.

    • You may need to apply some gentle force to detach the covers. Be careful not to break the plastic screw pins.

    It took force to open it, but i broke a plastic pin where the screws enter

    Vasco Mateus -

    You can use a pick to get the thin edge up without breaking anything.

    Mira Mogzec -

  7. TlVTEuM4vBKmcycD

    • If done correctly, you should have a fully detached plastic backing, revealing the electronic components of the PlayStation 2.

  8. OTGWunfrXxw6M1LD
    OTGWunfrXxw6M1LD
    gfC2BDgYlvElRhIc
    aycYdQ2LV1VNwqoM

    • Locate the IR sensor on the motherboard. Then, use tweezers to gently detach the blue/white ribbon that attaches the IR sensor to the motherboard.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Jared Hirata

Mitglied seit: 10/04/13

681 Reputation

0 Kommentare