Porter-Cable PCE211 Grip Replacement

Geschrieben von: Layla Berry

Kommentare: 0

Schwierigkeitsgrad

Moderate

Schritte

Zeitaufwand

45 Minuten - 1 Stunde

Einleitung

If you need to replace the grip of your Porter-Cable PCE211 impact wrench, follow this guide. You'll need to remove the grip to access the switch as well.

Be sure to turn off the device and unplug from the power source prior to beginning this repair.

Werkzeuge

Schritt 1

Using the Hex Security SAE 7/32", remove the four 10 mm socket screws at the base of the gearcase.

Schritt 2

Grip the body of the impact wrench with one hand and the gearcase in the other and firmly pull to remove it.
Be careful about any loose parts when removing the head.

Schritt 3

Remove the four 6 mm screws using a Phillips #2 screwdriver.
The screws are tight so you will need to use a bit of arm strength.

Schritt 4

Pull the rear housing off the back of the impact wrench.
Be careful when removing the rear case that loose parts don't get damaged.

Schritt 5

Firmly pull the to remove drill bit holder also known as the anvil.
Before replacing the anvil, lubricate the base for the best performance.

Schritt 6

This section tends to get messy so it would be best to have a paper towel or microfiber towel handy.
Pull the motor out with your hands.

Schritt 7

Wipe out the old grease with a towel. Use the appropriate motor grease for electric tools to lubricate the top area, base of the motor, and the space the motor sits.