Einleitung
Bypassing the valve and relieving tank pressure are crucial if you want to perform any maintenance or physical inspections of internal components... unless you want a cold shower and flooded basement.
-
-
Locate the RED bypass knobs.
-
Using an allan key or a pair of pliers, turn the knobs so the stamped arrows are facing each other.
-
CAUTION: The bypass knobs may become detached, if this happens take note of the position of the knob and return the knob to that position and press down to reseat it.
-
-
-
Unlock the valve.
-
Press and hold the {MENU} key until the valve beeps/the padlock icon disappears.
-
-
-
Activate manual regeneration
-
After the valve is unlcoked, press the [MENU] button once more to bring up a menu prompt.
-
Repeatedly press the {DOWN] button until "Manual Regen" is selected.
-
Press Set
-
Use the [UP} arrow to select "Regen Now" and press {SET} to begin the regeneration process.
-
-
-
Press and hold any button for approximately 3 seconds to skip ahead, do this until the valve is in either BACKWASH or RINSE.
-
Wait until the time begins to count down to ensure it is has relieved pressure
-
Note: If you have a Downflow valve or are using this valve on a filter your first regeneration cycle will be BACKWASH, you won't need to skip ahead.
-
Note: The valve may take a couple of minutes to move between cycles, please be patient with it.
-
-
-
Finally, disconnect the valve from the power supply by unplugging the 12v A/C adapter from the wall.
-
Your valve is now bypassed and pressure has been released, you may now perform any maintenance or inspections to your heart's content.
