Einleitung

Using this guide you will be able to replace the tuning wheel. If the radio station doesn't change you might have a problem with the motherboard.

  1. UDSNgZSXDcPOkCxS
    UDSNgZSXDcPOkCxS
    DENsulSRatZWXAEL
    • Push down on the clip to release pressure. The pull off the plastic cover.

  2. 4BovUQcJMFlSaWPr
    • Remove the 9-volt battery from the battery terminal.

  3. ZijJUuFhEkvXtNkL
    • Take out the six screws located on the back of the device.

    • The red screws are 10 mm Phillip's #1. The orange screws are 13 mm Phillips #1.

    • Three screws are located on the back panel. One is located inside the battery carriage.

    • Two screws are located on the on the back panel on the bottom left and right side.

  4. hwsQyiOJDT6fM55R
    hwsQyiOJDT6fM55R
    nJsxgDgKGpHQwFZk
    l4Ia1a2hm2Ln32xS
    • Remove the 10 mm Phillip's #1 screw.

    • Then remove the metal reinforcement.

  5. A4DDyIfEACjf4vn6
    A4DDyIfEACjf4vn6
    GRIrKZGNJhSEmdgK
    • Using flathead screwdriver undo the release tabs.

  6. LBGjVybXTyw5wAIk
    LBGjVybXTyw5wAIk
    hEd1qDkF23SIqCYt
    El5xXXtP5XCpCljQ
    • Pry the release tabs with a spudger.

    • Start with back of the device on the topside.

  7. AN2tCmEBrhtSTXJO
    AN2tCmEBrhtSTXJO
    JgwcFb2brX3TiGDf
    • Pry open both tabs to remove the topside of the clock.

  8. cHmSsLGnqljTYLVk
    • Remove the two 10mm Phillip's #1 screws. Also remove the two reinforcements holding the speaker in place.

  9. phegIxDeuhsPhUIX
    phegIxDeuhsPhUIX
    oQaKmarafKQPAGxJ
    • asd

  10. MKLSjHGVSNNWoveH
    • Remove the top 5 10mm Phillips #1 screws holding the top part of the motherboard

  11. jWODvj4pvWICl3gB
    • Remove the 5 10mm Phillip's #1 screws that holding side part of the motherboard

  12. dhrbcCuMwaZN4QPl
    • Remove the transformer by pulling back the release tab shown.

  13. 6ZSIiiwEPEiL4S4T
    • Pull the battery terminal through the whole shown.

  14. MsESKwe3ShsVyeTv
    • First release the latch highlighted in the picture. Then grab the screen by the bottom and lift it up.

  15. JiXK1pycOBRtWyIV
    JiXK1pycOBRtWyIV
    uVsZSKBBepDCKVJr
    koYNBs6rfXBhC2lb
    • Remove the motherboard from the frame using the illustration shown.

  16. l55L5R14EV5joV4S
    • Tuning wheel, lift it up and replace it with a new one.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Alexander Trowell

Mitglied seit: 22/09/14

222 Reputation

0 Kommentare