Razer Huntsman Tournament Edition Port Replacement

Geschrieben von: Joseph O'Dowd
  • Kommentare: 0
Razer Huntsman Tournament Edition Port Replacement

Schwierigkeitsgrad

Moderate

Schritte

11

Zeitaufwand

1 Stunde

Einleitung

If your port is either wobbly or non-functional, use this guide to replace it. This guide should take a half hour.

The Razer Huntsman Tournament Edition is a tenkeyless mechanical keyboard. Its USB port is easily swappable, being held in by a screw and a cable.

You must know how to remove the back of the keyboard before beginning this guide.

  1. 5tEiymEdtBJsVkb2

    • Place the unplugged keyboard on a flat, clean surface appropriate for working on.

  2. pKJvZfxRWdOKSdBO
    pKJvZfxRWdOKSdBO
    A5SYbGYk2EhHYGnF

    • Grip the keycap with your keycap puller.

    • You can remove keycaps with your fingers if you don’t have a puller, but the adjacent keycaps must be removed first for sufficient grip.

  3. ypxwG6HKqYEJZ5rE
    ypxwG6HKqYEJZ5rE
    jG5qffwEXkUQDK5E
    jjutFKDvejrLq164

    • Pull with an upwards force to remove the keycap.

    • Take a moment to clean the area that was previously obscured if it’s dirty.

    • Use gentle force so as not to damage the stabilizers.

  4. KSUPZsuf1dswpmD5

    • Remove all of the keycaps with a keycap puller.

  5. rjg2YU4Hb5ifHmO2
    rjg2YU4Hb5ifHmO2
    H6QN3C5WulxVRNeP

    • Unscrew the thirteen 6.5 mm screws, using the Phillips #0 screwdriver, that are located in the front panel.

  6. kgrQ1daHhqZh1aKM

    • Use an opening tool to pry open the chassis.

    • Be careful not to use excessive force during this step so the plastic doesn't warp or break.

  7. NFMxRtYLWUQbSFlg

    • Gently lift the front panel off.

    • The front panel should be connected to the USB board. Do not tug the panel off as this may damage other parts.

  8. aUOhXNh4SIJysTLO

    • Disconnect the internal cable.

  9. GhTBXp33xMOoVZLU
    GhTBXp33xMOoVZLU
    2RODDyLauZDfKIQV

    • Unscrew the board with the port.

    • It should be located on the upper left, held in by two 6.5mm Phillips #0 screws.

    • Move the cable out of the way for the second screw

  10. kktaJg5Fn3WB6yqA

    • Detach the internal cable from the USB board.

    • Do this carefully.

  11. iWfGYOWlAp3hITjX

    • Remove the USB board.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Joseph O'Dowd

Mitglied seit: 25/10/22

356 Reputation

0 Kommentare