Einleitung
Werkzeuge
-
-
Pry off back plastic, starting at the gap provided at the bottom of the phone. A spudger can be used to make this easier.
-
-
-
Remove 4 corner screws, you may have to remove a "VOID" sticker from one of the screw heads.
-
-
-
Using a spudger, unclip the nine clips holding the back panel to the front panel, highlighted in included pictures.
-
Start at the top, and work clockwise, being careful not to break the clips.
-
There are, 1, 3, 2, and 3 clips on each side, respectively.
-
After the clips are disengaged, there are no cables holding the back panel in place.
-
-
-
Use your spudger to release the remaining clips, disconnecting the ribbon cables from the logic board.
-
-
-
Remove 2 Phillips Screws holding the logic board to the front panel.
-
Gently lift the logic board off the front panel.
-
To reassemble your device, follow these instructions in reverse order.