Ricoh Theta S Outer Case Replacement

Geschrieben von: Bradley Sutton
  • Kommentare: 3
Ricoh Theta S Outer Case Replacement

Schwierigkeitsgrad

Moderate

Schritte

3

Zeitaufwand

5 - 10 Minuten

Einleitung

This guide will show the steps to remove the outer case for the Ricoh Theta S. Be aware that any replacement of disassembly of the original product may void the manufacturer warranty.

  1. JNP4qBaKs2S3Stao

    • Wedge the spudger underneath the small plastic square located on the bottom of the device.

    • Move the spudger to remove the plastic cover.

  2. bM3FCQtLXdUSLLNZ
    bM3FCQtLXdUSLLNZ
    D6ZFANZpnNofWEa2

    • Remove the four 3-mm screws located on the bottom of the device. You will need to use the Phillips 00 screwdriver.

    when doing this careful as the screws do strip

    david.demian -

  3. To5xOeUiJGF6iUYO
    To5xOeUiJGF6iUYO
    tRpNbdP2nJiQFOxy
    PcorgMAlZTPvInsw

    • Insert the plastic opening tool in between the panels shown.

    • Apply pressure to unlatch the 9 spring clips located around the perimeter of the device.

    • Lift the panel from the device.

    thank you for the instructions. Keep in mind that the Spring clips are just on the other side of the phone, the side without the photo button. Then metal casing is attached to the front and can bend easy. So be careful here. If you get a red light, 5 beeps, and the device turns off, it means you’ve got a physical error code, and you need to investigate. In my case, I disconnected one of the flex cables to one of the cameras, and this needed to be redone.

    david.demian -

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Bradley Sutton

Mitglied seit: 07/11/17

737 Reputation

Ein Kommentar

Where can find spare part case?

Thanks

Franco -