Rival CM4015 Heating Element Replacement

Geschrieben von: Michael Murdock
  • Kommentare: 0
Rival CM4015 Heating Element Replacement

Schwierigkeitsgrad

Moderate

Schritte

12

Zeitaufwand

15 Minuten

Einleitung

The Rival single cup coffee maker has a heating element that is prone to breaking. If the device is left on for too long, the heating element can over heat and stop working.

  1. on5ASLa4WnEjqPWL
    on5ASLa4WnEjqPWL
    gK6FOHsXQuhOLUT3

    • Remove the three 16 mm tri-point screws from the base plate.

  2. wWsAyxTILAyrIJKN
    wWsAyxTILAyrIJKN
    earsd2KGdiDgxrOV

    • Remove the base plate by pressing the plastic body away from the metal plate with your thumbs.

  3. 4Mbyr2HldRknwaVJ

    • Remove the 8mm Phillips screw that attaches the power button to the inside of the coffee maker.

  4. XB4J2bhipQJT5UsG
    XB4J2bhipQJT5UsG
    ru356uC5AERyRZhB

    • Use a flat head screwdriver to pry the power button from its slot in the body of the device.

    • Make sure the tool is pressed securely under the plastic clip, in order to not break it.

  5. YnsXYPKuAUVWq2qw
    YnsXYPKuAUVWq2qw
    HZOA2lYcpEHVeWto

    • Clean both the button and its slot before replacing the power button.

  6. C12byPcyrHNbpWXD

    • Remove the two 8 mm Phillips screws from the plastic body.

  7. BbbML5WPpOIBQStF
    BbbML5WPpOIBQStF
    JpYSkHlgo6MhCFbs

    • Remove the two 8 mm Phillips screws from the chassis of coffee maker.

    • Pull back the metal backing from the plastic body.

  8. Eqa3CTygXKu5xIQM
    Eqa3CTygXKu5xIQM
    TFkePsuJqKhuxIK6
    HqBWO5NdQkYYxHNH

    • Remove the four 8 mm Phillips screws from the inner plastic body.

    • You will need a long, thin Phillips screw driver to get this deep into the device.

  9. bviYMZMBqMOoSiwr
    bviYMZMBqMOoSiwr
    pLFtdkhg4SPYhsTW

    • Flip the device upside down and remove the outer plastic body from the device by pulling straight up.

    • Take your time to make sure the thin cables within the device don't tear.

  10. L2uJTZC4dJixNsuK

    • Remove the two 8 mm Phillips screws from the metal backing.

  11. RmNFmFgSyJrd5hKF

    • Remove the 4 springs holding the water tubes by squeezing the 2 prongs together.

    • You may also use pliers for this step if the springs are too strong.

  12. 4ZcK4KZUNnMup5Fd

    • Bend the heating element back and forth to wiggle the water tubes loose from the plastic.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Michael Murdock

Mitglied seit: 06/10/16

261 Reputation

0 Kommentare