Einleitung

  1. kS5cXITxUZuPZKKX
    • Unplug the power cord.

    • Flip the device over so the bottom is facing up.

    • Remove the two 10mm screws holding the back panel using a Phillips #2 screwdriver.

  2. cOXA3AuCa5rEMcio
    cOXA3AuCa5rEMcio
    VH6tsS2IB2GQZLQP
    Luj6IeWFTuPXTSZF
    • Place the Flathead Screw driver parallel with the gap between the back and the heater body, then twist until the two parts of panel are separated. You may have to do this on four sides of the panel.

    • Remove the front panel by pulling them apart. The front panel should come out easily.

  3. wqVHZZaTLpUEWlRf
    • Remove the two dial caps from the two switches by lifting them up.

  4. WL6lnHpYthfwnxNG
    • Remove the two 10 mm Phillips screws using a #2 Phillips screw driver. One attaches the gold metal bracket to the heater coil housing and the other attaches the fuse holder to heater coil housing.

  5. GmJGZ5WbOAUBpUkb
    GmJGZ5WbOAUBpUkb
    cZBCbQVgtAhpFMWd
    • Make note of where you disconnect the wires from so you can properly connect them when re-assembling heater.

    • Unplug the wire that goes from the bottom of the power switch to the heater coils. To unplug pull down on the wire until it breaks free.

  6. Rn1aaGLfENYARmhR
    Rn1aaGLfENYARmhR
    X5LdJZETLxN5AdxJ
    • Make note of where you disconnect the wires from so you can properly connect them when re-assembling heater.

    • Unplug the wire that goes from the bottom of the power switch to the fuse holder. To unplug the wire, pull the wire away from the fuse holder.

  7. PYUMpXhhlV6TdsNb
    • Make note of where you disconnect the wires from so you can properly connect them when re-assembling heater.

    • Unplug the wires located on the right side of the heat coil housing. Both plugs will come off together. To unplug the wires, pull down on the wire until it breaks free.

  8. i2BiZNrDZOeSDEA5
    i2BiZNrDZOeSDEA5
    b2iVK3DImMTgCfGV
    • Grab the Switch and Circuit Board Assembly with one hand and slide it up. You will need to wiggle it to break it loose. While wiggling it, slide it up until it is clear of the plastic rails.

  9. neICmNR4JRCjFs3K
    neICmNR4JRCjFs3K
    EeFphsQJbRLAYv2t
    • Make note of where you disconnect the wires from so you can properly connect them when re-assembling heater.

    • Unplug the two wires, with blue ends, that go from the Power/Fan switch and from the bottom of the Circuit Board to the fan. To unplug the wires, pull them away from the fan assembly until they break free.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Jorge Revelo

Mitglied seit: 15/10/13

212 Reputation

0 Kommentare