SONY SRS-X2 Face Plate Replacement

Geschrieben von: Megan Berthiaume
  • Kommentare: 0
SONY SRS-X2 Face Plate Replacement

Schwierigkeitsgrad

Moderate

Schritte

4

Zeitaufwand

Keine Schätzung

Einleitung

  1. m51CdcMuxJnJOoEy
    m51CdcMuxJnJOoEy
    l1DW3e5SyiyrAVBh

    • Use the metal spudger to pry the face screen open. Pull away from the device to remove.

  2. a2fP1sbFAiVFiStb
    a2fP1sbFAiVFiStb
    ZAHm3k4dDRFcrxB4

    • Remove seven, 27 mm long Phillips #1 screws.

    • Remove three, 11mm long Phillips #1 screws.

    • Remove four, 10 mm long Phillips#1 screws.

  3. YOfKRYqWJP1APmvP
    YOfKRYqWJP1APmvP
    ILVXw4rwKjR1RUmt

    • Before removing the host plate, face the feet of the speaker to you. The wiring allows for minimal access to the inner components.

    • Use the spudger to remove the speaker host plate. Insert the metal tip in the seam between the host plate and the shell.

    • Be very careful when pulling the speaker host plate (described in the next step) as there are wiring connected to the host plate. This wiring is soldered to the plate and to the shell of the device. The wires are flexible and you can still open the device as shown in the second picture.

    • Center the spudger on the top of the device, this is furthest from the wiring, in wiggling the spudger under the plate, the plate should move up and out of the shell, you can finish lifting the plate away with your fingers.

  4. uGa6vsRTkVrkWQKO
    uGa6vsRTkVrkWQKO
    cQIEqy2UDAawnBLI

    • Be gentle when using the opening tool, wiggle the opening tool on each side of the socket to be sure the plastic does not snap.

    • Be careful not to damage the wires, pull from the plastic base to unplug.

    • Unplug the power cable connector shown using the plastic opening tool. Wiggle the tool under the lip of the plug, the smaller area and odd angle means lifting up with the plastic tool in the setup shown.

    • Unplug the power connector shown using the plastic opening tool lift from the front of the plug shown and move the opening tool to either side to get it all the way out of the socket.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Megan Berthiaume

Mitglied seit: 04/10/16

484 Reputation

0 Kommentare