Einleitung

Use this guide to remove the front casing and to access the keypad.

  1. ZomAOAjdOHoO4STS
    ZomAOAjdOHoO4STS
    dRGZl3vclIKnrN22
    YZy4JRxZyRFyLWQ1
    • Apply downward pressure to the top of the battery panel while pulling down to slide it off the phone.

  2. HBWKTIbDfRdayjrJ
    HBWKTIbDfRdayjrJ
    NOPDnw6uCoDhTMOX
    qbeQqgy5P5S5WPiI
    • Locate the grooves on the sides of the battery near the bottom of the phone. Use your fingers to pull the battery up and out of the phone.

  3. 4yvu6wlibjdo4cXe
    4yvu6wlibjdo4cXe
    bo1BLTVhagpT2Y5e
    • Use the spudger to pry the two plastic caps out of the top corners of the phone casing.

    • To get a better grip, you may use the tweezers to finish pulling the plastic caps from the phone.

  4. vIrkRKGrB1Xt2eiC
    • Remove the six 4.0 mm screws using the Phillips 00 screwdriver.

  5. ebVYgNSAIgZgSpI3
    ebVYgNSAIgZgSpI3
    hI6PyKAyAhu6P1Ox
    6tkyYUeNKOYmmiGT
    • Insert the plastic opening tool in the gap between the back panel and rest of the body.

    • Slide the tool along the edges until the two pieces come apart.

    • The circuit board is attached to the front casing. Both casings should separate without having to sever electrical connections.

  6. QpcMlTHZZYjomxCu
    QpcMlTHZZYjomxCu
    xUNOKeFb1LQ5eGMw
    • Pry apart the plastic tabs along the edges of the phone.

    • Separate the front panel from the main body of the phone using your fingers.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Ryan Rumsey

Mitglied seit: 31/01/13

8 Reputation

0 Kommentare