Einleitung

Step-by-step guild to replacing your old worn out keyboard buttons.

  1. an1UJHBgJ6BBmQcC
    • Press button on back of phone below camera.

    • While button is depressed, remove the back panel of the phone by sliding off (not shown in picture).

  2. QSlJjllirVoiGyWQ
    • Grasp the battery near the bottom with two fingers.

    • Lift battery up and out gently.

  3. JooUWrEtvlTRVPrC
    • Using an iPod opening tool, remove the screw cover in the top left corner by lifting it up.

  4. EHGMsOVCGTWIiWVD
    • Use the Phillips #00 screwdriver to remove the six screws on the back of the phone. Three are evenly spaced on each side.

    • The upper right screw is 4.5mm while the rest are 6.5mm.

  5. xg1gUVwGWIbRWvOr
    xg1gUVwGWIbRWvOr
    NFOXoLZ51ZPpEIRJ
    • Slide the iPod opening tool into the seam on the side of the phone and turn it slightly to unhook the eight clips.

    • There are three clips on each side and two at the bottom of the phone.

  6. WBQQ6PQkGQxFaqZA
    • Once all eight of the clips have been unhooked, lift the back panel off of the phone.

    • Be careful not to remove the front panel. It is still connected to the phone chassis by a ribbon cable located in the bottom right side of the motherboard.

  7. smRGMJ1Ae15mfs3v
    • Using an iPod opening tool, unlatch the ribbon cable located in the lower right corner of the motherboard.

    • Carefully remove the ribbon.

  8. NhNxC4h3vTJZvOKp
    • Remove the front faceplate.

  9. FkuBPeKAUQMRCFt3
    • Grasp the rubber keyboard in the corner with your fingers and lift to remove.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Chris

Mitglied seit: 20/04/11

23 Reputation

0 Kommentare