Samsung Galaxy J3 Eclipse Display Assembly Replacement

Geschrieben von: Chandler Casey
  • Kommentare: 1
Samsung Galaxy J3 Eclipse Display Assembly Replacement

Schwierigkeitsgrad

Moderate

Schritte

5

Zeitaufwand

20 Minuten

Einleitung

This guide will help you fix a broken or shattered screen on your Samsung J3 device.

  1. udrxbPLMVbGtfFup

    • Use a heat gun or hair dryer to heat up the front edges of the phone for about two minutes. Stay approximately six inches away from the screen to prevent phone damage.

    • Do not apply heat to any one edge of the phone for longer than a few seconds. Instead, use a continuous motion around the phone's edges.

  2. YKC1FCeYHHdDrOgJ
    YKC1FCeYHHdDrOgJ
    R4BLyW2BDqTPx2hR

    • While the screen adhesive is still warm and flexible, insert a pry tool or plastic card between the glass display and the frame of the phone.

    • Slowly slide another pry tool around all the edges of the phone in order to break the adhesive's bond to the display.

    • When using the pry tool, do not use too much force or the phone's internals could be damaged.

    • Do not insert your tool more than 1cm into the top edge of the phone to avoid damaging the fragile cables.

  3. O5l5ey1d2Pd3HyXl
    O5l5ey1d2Pd3HyXl
    sJlDalYALtlwCmdG
    ZGLjPAypBXvYVDN1

    • Gently lift lower side and loosen all edges to hinge screen up from bottom.

    • Do not try to completely remove the display from the frame yet. Simply try to loosen up all the edges.

    Top half??? That is where cable is located, the most likely to be damaged. NO, use lower side and bottom half, then gradually loosen top edges. Hinges up from bottom.

    B. A. Computer Services -

  4. ON5fKnE5Q1BxpGEo
    ON5fKnE5Q1BxpGEo
    oltJKpkfHj4CIvZD
    5KgSOTmTlTUmquLi

    • Use your prying tool to slowly pry up on the bottom right corner of the white cable guard, exposing a thin ribbon cable connector.

  5. lHdoIfCSbySsCl6m
    lHdoIfCSbySsCl6m
    qbdWDlIrxPRVnVRK
    kIEKAVvmHX2CrA1h

    • Pry up the ribbon cable connector revealed from under the cable guard and remove the display from the device.

    • Clean the residue from the phone edges before re-assembling phone with new screen.

Abschluss

To reassemble your device, connect all cables, apply fresh screen adhesive and follow these instructions in reverse order.

Tinte & Feder

Chandler Casey

Mitglied seit: 21/09/18

774 Reputation

0 Kommentare