Samsung Galaxy Tab S2 9.7 AT&T SIM Card Holder Replacement

Geschrieben von: Joy Harris
  • Kommentare: 0
Samsung Galaxy Tab S2 9.7 AT&T SIM Card Holder Replacement

Schwierigkeitsgrad

Moderate

Schritte

8

Zeitaufwand

20 - 25 Minuten

Einleitung

A broken SIM card holder or memory card holder prevents your tablet from connecting to your network or storing memory, respectively. Before starting, eject the SIM card and memory card trays.

  1. BhUKYWB5NjCCEsQd
    BhUKYWB5NjCCEsQd
    VVik2T5JBoFx4uSg

    • Apply the heat gun around the edges of the tablet to melt the adhesive glue.

    • Do not allow the gun to remain still for more than two seconds, so that you do not melt the plastic around the screen.

    • If you do not have access to a heat gun, you may also use an iOpener or a hair dryer. Refer to the iOpener guide for extra help.

  2. DaNbJv3KM2DfV5RE
    DaNbJv3KM2DfV5RE
    qrqswQIIxw3YRruU

    • Apply the suction to the bottom or top right corner.

    • Use the plastic opening tool at several points around the screen while the suction is being applied to pop the screen out.

  3. yPkoIqqeXCLZJOFJ

    • Once the screen is detached, open the tablet like a book.

    • Gently open the tablet, and do not pull the pieces apart since you can risk damaging the orange ribbon cable.

  4. QwJBEIY1i3tLXpPD

    • Using the precision tweezers, remove the silver tape that is holding the orange ribbon cable connecting the two pieces.

  5. 5yupmPhcXYxaKPMv

    • Using the precision tweezers, remove the small press-fit connector from the body of the tablet.

  6. JXVLGk5Dn3ZKjk4b
    JXVLGk5Dn3ZKjk4b
    Bh3rX4RXgKWelFaj

    • Using the Philips #000 screwdriver, remove the seventeen 2.74 mm screws around the edges.

    • Remove the two 2.74 mm black screws in the middle of the tablet with the Philips #000 screwdriver.

    • Put the screws on a magnetic project mat or in a container so that you do not lose them.

  7. C1BKtheWAjij1iwx
    C1BKtheWAjij1iwx
    F1Auyje6OfuIJKlb
    kDuRAr1CpZU4qDTM

    • Take the plastic opening tool around the tablet to remove the motherboard from the device.

  8. SUPekDukTSQZIonX
    SUPekDukTSQZIonX
    mh5mFiqacnFjDAR4

    • Locate the SIM card and the memory card holders along the right side of the tablet.

    • Using the precision tweezers, remove the SIM card and memory card holders.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Joy Harris

Mitglied seit: 15/02/17

814 Reputation

0 Kommentare