Samsung HMX-W300 Battery Replacement

Geschrieben von: Robert

Kommentare: 2

Schwierigkeitsgrad

Difficult

Schritte

Zeitaufwand

15 Minuten

Einleitung

The battery is located inside the camera. To remove the battery, it will require uninstalling the battery housing. This can be done in a few steps found below.

Werkzeuge

Schritt 1

To remove the wristband of the device, grab the middle loop and pull the band through.

Schritt 2

Remove four screws with a Hex 1.5 mm screwdriver.

Schritt 3

Open the HDMI door on the side of the camera.
Remove the single screw using a Phillips #00 screwdriver.

Schritt 4

Use the iFixit opening tool on both sides on the device. Pry apart both sections with light force.
Do not apply too much force. There is a wire that attaches the front case with the rear case that can be damaged.

Schritt 5

Pull the wire ribbon out with a pair of tweezers.

Schritt 6

Remove the four screws from the battery housing using a Phillips #00 screwdriver.

Schritt 7

Use the iFixit opening tool to pry the battery housing open.

Schritt 8

After removing the battery housing, take the battery out.

Abschluss

To reassemble your device, follow these instructions in reverse order.

2 Kommentare

What type of battery is this? What part number should we use to order a replacement?

VanDemark - 01/06/19

The type of battery should be printed on the case of the battery. Most likely it’s some type of lithium battery. The part number for the battery should be on the case as well. If you can’t find either of these on the battery case you can take the battery to a place that sales batteries and the personnel there should be able to tell you the type and part number for your battery.

Jarretti Reaves - 02/04/20