Samsung Rogue Speaker/Antenna Replacement

Geschrieben von: Viktoria Mikoultchik
  • Kommentare: 0
Samsung Rogue Speaker/Antenna Replacement

Schwierigkeitsgrad

Moderate

Schritte

10

Zeitaufwand

15 - 20 Minuten

Einleitung

This guide will provide a step-by-step procedure for replacing the antenna and speaker in your Samsung Rogue.

  1. kwfNALJHelngV52O
    kwfNALJHelngV52O
    EOU4I3IToTSgDEwc

    • Before disassembling your Samsung Rogue, make sure it is powered off.

    • With your thumbs, push down on the back cover of your phone and slide it away from the camera.

  2. JMswmFGHrjTicvVt
    JMswmFGHrjTicvVt
    SfZL51juyGQonjNO

    • You can now remove the battery by prying it up with your finger.

  3. kDOxOtee4YPjofVW

    • Use a plastic opening tool to carefully pry the back cover surrounding the camera up from the phone.

  4. mSaYe5AMA2OYv3Kb

    • Remove the five 3.4mm Philips screws securing the backing of the phone.

  5. 1ptIgT5Sefo46SEC
    1ptIgT5Sefo46SEC
    4EWaXZtW4RPa2ggC
    TZCTxDYLbsqcsecj

    • Use a plastic opening tool to carefully pry off the back cover.

    • Make sure you are prying along the edge and not between the two halves of the phone that slide away from each other.

    • Be careful to not drop the volume changing piece, for it can easily slip out.

  6. IFNUN5D5PmJdqOAX

    • Remove the two 3.45 mm Philips screws below the white sticker.

  7. ayZNQYiuuxEHEHXl
    ayZNQYiuuxEHEHXl
    QDldbHTLqKRLGkLc

    • Carefully lift the motherboard up from the bottom edge.

    • The film of wires is still attached to the motherboard, so do not completely remove the motherboard just yet or you may damage it.

  8. lYAU52j6iZWL2KeP
    lYAU52j6iZWL2KeP
    2TUXWQsZrlWOFULV

    • Use a plastic opening tool to disconnect the film from the motherboard.

  9. JtnWvrsMbXKuyRUA

    • On the underside of the motherboard, remove the single 3.3mm Philips screw.

  10. cDhNGI4Iwg1PPdJn
    cDhNGI4Iwg1PPdJn
    UdgUTPGD3MEyYwM2
    UE4YylnXRKXWybNO

    • The speaker and the antenna are both connected on the same black piece.

    • Use a plastic opening tool to pop off the edges of the speaker/antenna piece from the motherboard.

    • Turn over the motherboard and carefully lift the speaker/antenna piece straight up.

    • The camera is held in the middle of the speaker/antenna piece. Make sure to lift directly up when lifting the speaker/antenna piece, otherwise you can risk damaging the camera.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Viktoria Mikoultchik

Mitglied seit: 15/04/12

25 Reputation

0 Kommentare