Einleitung

  1. dXifXxW1lcjaZAGU
    dXifXxW1lcjaZAGU
    14NFQgXttCg4wi1v
    • Place the phone so that the back is facing you. Depress the locking tab on the back of the phone with a finger or thumb.

  2. waUvSSPR3EjLk3Iv
    • Slide the battery toward bottom of the phone, about a quarter of an inch, to clear the hooks that keep it secured to the back of the phone.

  3. mVHvyPrVbvA2DUei
    • Lift the battery away from the phone case.

  4. idJBpyksjLKAhtKj
    idJBpyksjLKAhtKj
    ELCL5LC6yCqev3wc
    • Grasp the antenna firmly and rotate it counterclockwise to unscrew it from the phone.

  5. OOWZdH6OgvjonBbM
    • When unscrewed, pull the antenna straight up and out.

  6. UxWMbkQWFEMlnLHx
    UxWMbkQWFEMlnLHx
    MP2NWhvyPLYfOZs1
    • Pull the guide tube free from its retaining ring and slide it out the top.

  7. dyRBQAs6fK4PcVud
    • Remove the four screws using a T6 Torx screwdriver.

  8. kJvCRhNyHCjYcQef
    kJvCRhNyHCjYcQef
    rgnR1sowUCwd2VdN
    • Work from the bottom of the phone, separating the two halves of the case.

    • Note: Take care to keep the logic board with the front case half. Part of the logic board is exposed to the sticker under the battery on the rear case half.

  9. ZTeahUoxWgoeyUMx
    • Angle the rear case half away from the top of the front case half, pivoting the hooks out of their clasps.

    • Caution: Do not fully separate the halves. There is an antenna ribbon connected to the logic board from the back cover.

  10. THwrGCQpekeIuBBh
    THwrGCQpekeIuBBh
    GVJDweIvZT4bRccE
    thuEtYNntvm5t4T5
    • Disconnect the antenna ribbon cable from the logic board at the Zero Insertion Force (ZIF) connector. The brown portion of the connector lifts up to release the cable end.

    • The Back Cover is now removed. Congratulations.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Brett Tomashitis

Mitglied seit: 09/03/12

36 Reputation

0 Kommentare