Shark ION Robot R75 Battery Replacement

Geschrieben von: Andrew Lowy
  • Kommentare: 4
Shark ION Robot R75 Battery Replacement

Schwierigkeitsgrad

Easy

Schritte

3

Zeitaufwand

2 Minuten

Einleitung

This guide will show the simple procedure of how to replace the battery on your Shark ION Robot R75. Before performing any maintenance or disassembly, ensure that the robot is turned off.

The battery supplies power to the vacuum while it is undocked and performing its cleaning functions throughout the desired area. While the robot should return to its dock at the end of its programmed path, it’s possible that the vacuum starts running out of battery before completing the program, especially as the device ages and the battery degrades. If your Shark Robot starts to die mid-cycle before reaching its charging dock, a battery replacement may restore your trusty vacuum to its former glory.

The part number for a replacement battery is RVBAT700 and can be purchased directly from Shark’s site.

  1. yd1jGlpLTDRc1hHf
    yd1jGlpLTDRc1hHf
    XNNtWHGMoY5GxiE5
    FEsGvqsPYxCsancT

    • Make sure the robot is shut off by pressing the power button on top.

    • Flip the R75 over so that the underside is facing up.

    • Using a Phillips #1 screwdriver, remove the 4mm screw in the battery cover.

    • Remove the battery cover.

    Here, you have misused the reminder bullet. The note bullet would be better in this case; I would also say how to turn it off, rather than just to do it. Avoid locate steps, and instead, move straight to the information about what to do. Use markup on the images to indicate where the component is. Be careful about using “remove” without other information about how to remove it, especially if there are multiple ways to remove something.

    Alex Watkins -

  2. eNek1rNlHGuxOQoA
    eNek1rNlHGuxOQoA
    guxEldPlLS5pacye
    GLpTIqMocSKtTEpG

    • Be careful when removing the battery, as it will still be connected to a wire.

    • Slowly pull the white tabs outward to remove the battery.

    Make sure to review how to appropriately use special bullets. Make sure to check throughout to remove “locate” steps, and instead, just go straight to the action.

    Alex Watkins -

  3. CqrfN2ORRlhjOLfR
    CqrfN2ORRlhjOLfR
    TDLOlROYnNnNHnAK

    • Be careful when removing the connector, as the part can break if too much force is used.

    • Push down on the tab of the battery connector using a set of tweezers and pull the connector away from the robot to free the wire.

    • Remove the battery from the device.

    Here, you’re using tweezers, but you don’t indicate that in the guide steps. Instead of including the information in the special bullet, I would just integrate the tool into the actual procedure. Do you have pictures of you pushing the tab? Can they yank the wire, or do they need to pull gently? I would add a flipbook style action shot to make the procedure clearer in the pictures.

    Alex Watkins -

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Andrew Lowy

Mitglied seit: 25/01/20

572 Reputation

Ein Kommentar

After charging for several hours, my robotic shark stops after 10 minutes. I can push the start button and it will run for another 10 minutes. This has been repeated several times with out it docking itself. What are your thoughts on this?

Marsha Moon -