Shark Ultimate Professional Heat Plate Replacement

Geschrieben von: Drew Carff
  • Kommentare: 2
Shark Ultimate Professional Heat Plate Replacement

Schwierigkeitsgrad

Moderate

Schritte

5

Zeitaufwand

Keine Schätzung

Einleitung

  1. myMHUmVoHfbWDXL5
    myMHUmVoHfbWDXL5
    GOPjDiRJgLPRXOKZ
    md46DHCjy1sGPFCn

    • Remove the two screws at the back of the iron.

    • Remove the back cover piece.

    • Make sure iron is unplugged and cooled off.

  2. DDHH5qAKmGYaaEGF
    DDHH5qAKmGYaaEGF
    HVfhmgbwEEZl1ZQG

    • Remove the two screws holding the white clamp to the iron.

    • Remove the two screws holding the black wires to the body of the iron.

    • Removing the left black wire will also free the red wire, attached by the same screw.

  3. SUQLDcOeY3WV3Gdr

    • Pull the split end of the power cord upward through the ball joint of the iron.

    • Set aside power cord.

  4. HFxBTNvrYeiCVvBk
    HFxBTNvrYeiCVvBk
    LEhjHaDXSugJXfRm
    AvjwfWe6kxmJXGyh

    • Remove remaining screws that hold a wire on the bottom (brown and blue).

    • Unscrew from left to right.

    • Unclip the black adapter piece on the bottom right.

    • Wires order (from left to right): Brown, Blue, Red, Black

  5. FGrAfpRHKgEqYGBI
    FGrAfpRHKgEqYGBI
    mKY2ZRbJiAB2qgLr

    • Remove two screws (left and right) affixed to circuit board.

    To get to the heat plate requires full disassembly. This guide covers about 1/2 the process.

    Mark Goerlitz -

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Drew Carff

Mitglied seit: 23/10/17

868 Reputation

Ein Kommentar

This is an incomplete guide. Why even put it up. So silly and ridiculous. Not Good at all.

Muhammad Ahmad -