Einleitung
The XLR connector is the point where the XLR cable is inserted into the microphone. The XLR cable then carries the sound to the amplifiers.
Werkzeuge
-
-
Holding the microphone connector in one hand and the microphone base in the other, line up the screw in the connector with the hole in the middle of the microphone.
-
Also, align the ridge on the microphone connector (located near the top of the connector) with the slot in the base of the microphone.
-
-
-
With those parts aligned, push the connector back into the microphone until the screw lines up with hole in the side of the microphone.
-
-
-
Using a small flat head screw driver, turn the screw in the side of the microphone clockwise until it is tight.
-
After installing the connector back into the microphone, it should be ready to connect to any XLR cable.
7 Kommentare
Hi. I have followed the steps to #3. “Using a small flat head screw driver, turn the screw in the side of the microphone clockwise until it is tight. “ However, the connector does not stay in place. It is still loose where the connector moves inside the microphone. I cannot get it to sit tight .
Joe Lee -
Hi. I followed up to step #3. However, the connector does not stay tight. It keeps on moving inside with a little push.
Joe Lee -
Hi. I followed up to step #3. But, the connect is still loose… Moves inside the microphone.
Joe Lee -