Slingbox 500 Motherboard Replacement

Geschrieben von: David Sullivan
  • Kommentare: 0
Slingbox 500 Motherboard Replacement

Schwierigkeitsgrad

Easy

Schritte

5

Zeitaufwand

3 - 10 Minuten

Einleitung

  1. AuHMu4tGYO1WxxcL

    • Remove the sticker on the back of the Slingbox that covers the rear screws using a spudger.

  2. bO2SdbxdJSmPvOTW
    bO2SdbxdJSmPvOTW
    EoMDx2yyi5avk2Xg

    • Remove the seven 7.9 mm rear screws from the device using a Phillips #1 screwdriver.

    • Flip your Slingbox so the bottom is facing upwards.

    • Remove the four 7.9 mm screws using a Phillips #1 screwdriver.

    • You may have rubber feet on the bottom of your Slingbox. If you do, just gently remove them with your hands and set them aside to put back on later.

  3. XlTs1pfFbHAwjjjo
    XlTs1pfFbHAwjjjo
    SOHmPoZrT6npXdaH
    qtLhmJJOS6DtuDH1

    • Remove the upper section of the case by rotating your Slingbox to view the back and lifting up on the higher corner.

    • Use the opening tool to disconnect the small clips in the front.

    • These may require some minor force to disconnect.

    • Remove the entire top of the Slingbox and set it aside.

  4. hnSLIK4WlpQKa1vI
    hnSLIK4WlpQKa1vI
    ULuBxFss1gl2BPMi

    • Remove five 9.5 mm screws from the motherboard using a Phillips #1 screwdriver.

    • Push down firmly on the screws as to not strip them when removing them as they may not spin easily at first.

    • After removing the screws the two metal tabs on either side will be free. Make sure to not bend them or accidentally damage the wires while doing further dissasembly.

  5. lqJiFtAHsQaxhDZT

    • Remove the motherboard from the lower case.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

David Sullivan

Mitglied seit: 19/10/21

365 Reputation

0 Kommentare