Sonos Play 3 Motherboard Replacement

Geschrieben von: Christina Santini
  • Kommentare: 3
Sonos Play 3 Motherboard Replacement

Schwierigkeitsgrad

Moderate

Schritte

12

Zeitaufwand

10 - 15 Minuten

Einleitung

The motherboard receives the sound from your phone and supplies it to the speakers. It also processes volume and internet adjustments

  1. SHZtpfGGCsrJdDGZ
    SHZtpfGGCsrJdDGZ
    ydrTeAC3AH3SvDDF

    • Insert a spudger along the edge of the screen and gently use it to pull the screen away from the casing. Slide the spudger along the length of the grill to detach all the clips holding it in place.

  2. cUJGjxPHjH4aIder

    • Gently pull the screen away from the body of the speaker, revealing the tweeter and two mid-range drivers behind it.

    • There may be a kind of black sticky adhesive holding the screen clips to the rest of the body; however, it was previously removed on our model.

  3. gmQsEKIeDGILBiax
    gmQsEKIeDGILBiax
    GZ6A2fEWDwVGBxtQ

    • Unscrew eight 1.5 inch Phillips #2 screws attaching the front speaker panel to the box.

    • Unscrew the single 1 inch Phillips #2 screw located on the left side of the panel. This may be hidden beneath the warranty void sticker that you'll want to remove.

    • Unscrew the single 3/4 inch Phillips #2 screw, which is the last thing holding the front panel to the casing.

  4. GOCnOFDcwe6cyTJg
    GOCnOFDcwe6cyTJg
    uqqXXYCJCbg3iWjp
    5X3xRm4ADFYpSHAj

    • Remove the front panel carefully.

    • Note that there are two layers to the panel that should stay in their original order.

  5. NthDU6wjJ6W2IxZM
    NthDU6wjJ6W2IxZM
    UHcoNIc1cIWsYh3u

    • Disconnect the front panel from the motherboard by gently reaching in and pushing the tab underneath the wire connector and pulling towards you.

  6. y3EJoGlcl2xFIFOm
    y3EJoGlcl2xFIFOm
    sMRuUvBxsZrGylrG

    • Gently remove the wireless card located at the bottom of the front speaker panel by pulling up and out with your index finger and thumb.

    You must first loosen the Phillips #1 screws holding the plastic brackets that keep the Wi-Fi card in place.

    Olivier Biot -

    On the Sonos Play 3 I opened, the Wi-Fi card lied flat below the plastic clips. Between the card and the clips, there were 2 rectangular foam pads glued to the Wi-Fi card.

    Olivier Biot -

  7. ALNjuLsNlgjm1mR3
    ALNjuLsNlgjm1mR3
    LVfFPeJiUP1ieWqE

    • Disconnect the motherboard from the power supply board by gently reaching in and pushing the tab underneath the wire connector and pulling towards you.

  8. ZfZVLJ5ThNNWBXaZ
    ZfZVLJ5ThNNWBXaZ
    egJTEORTbVMiocvV

    • Disconnect the motherboard from the volume button board by gently grabbing the connector and pulling it towards you.

  9. jQiEfIBsvPBkltIu

    • Using a Phillips #2 screwdriver, remove the 4 screws securing the two plastic panels down.

  10. lobMKBEOVSbdYgf4
    lobMKBEOVSbdYgf4
    JGaN3AJDEuL6JTEO

    • Remove the two plastic panels on either side of the device that hold the motherboard and power supply board in place.

  11. nERcMcxsUYoPUfYc

    • Using a Phillips screwdriver, unscrew the two screws in the back of the device that hold the motherboard in place.

  12. ITfXQbthCBbnxm5G
    ITfXQbthCBbnxm5G
    MpXGpiYWJ5Z5tGFV
    qFBSgJEmMHHfOygh

    • Gently remove the motherboard from the Sonos device by sliding it straight back towards you.

    • When putting the motherboard back inside the device, make sure it slides in the slots smoothly on both sides.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Christina Santini

Mitglied seit: 14/04/16

1323 Reputation

Ein Kommentar

Where can I buy a new power board?

Roger Beasley -