Sony Alpha 6000 Back Cover Replacement

Geschrieben von: Vic Rebernigg
  • Kommentare: 10
Sony Alpha 6000 Back Cover Replacement

Schwierigkeitsgrad

Moderate

Schritte

10

Zeitaufwand

15 Minuten

Einleitung

This guide is to replace the back cover of the Sony Alpha 6000 camera if it happened to be damaged or if any parts that are located below it need replacement.

  1. 4lelWmLVGQGGTqKD

    • Make sure the camera is turned off by turning the switch to OFF.

  2. RMPOM5A5jakaH2m6

    • Flip the camera around to access the battery compartment.

    • Slide the battery compartment lock to the left to unlock it.

  3. ie2TWmxvesIi1ICC

    • Locate the blue latch that holds the battery in.

  4. f1nE4EXFAngCSkkv

    • Push the latch back to release battery.

  5. I4roq2LSfmLNeN1J

    • The battery can now be taken out of its compartment.

  6. SUnP4RiwFAZprlgd

    • Turn the camera upside down and unscrew these two bottom 6 mm screws located on either side of the body by using the J00 head screw.

    This step is not necessary.

    Jocelito -

    I think it is necessary…

    Torsten S. -

  7. S4BFshqGywVwOkGl

    • Turn the camera sideways.

    • Open the mini HDMI compartment and locate the two 6 mm screw underneath and another to the right of the compartment.

    • Unscrew using the J00 head screw.

    This step is not necessary.

    Jocelito -

    I think it is necessary…

    Torsten S. -

  8. oLOPUfiuGDvgKLLL

    • Locate the two 4 mm screws within the battery compartment and unscrew them using the J00 screw head.

    There are one more screw near the blue latch.

    Jocelito -

    Jocelito is right.

    Torsten S. -

  9. npFxPkwlRL516hwL

    • Bend the camera's screen forward to uncover two 3 mm screws below the eyepiece.

    • Locate them and unscrew them.

    There's also a screw under the dial just to the right of the viewfinder. You have to pull off a sticker in the middle of it to access. I also removed the top part of the camera in order to easier remove the back. It may not be necessary to do this.

    Margar -

    That is correct, I think it is necessary to do so, at least it is much easier that way.

    Torsten S. -

  10. RVWMBdCmjG3HTfli
    RVWMBdCmjG3HTfli
    OBcOIdoGqvTOGQ4D

    • Use a plastic opening tool around the body of the camera to wedge the back cover off. Start from the bottom next to the battery compartment.

    • If necessary, lightly use your hand to pull the the back cover down to completely remove it.

    Is not necessary remove the back cover to remove the top cover.

    Jocelito -

    But it is necessary to remove the back cover to change the Jog Wheel and that is what the instruction is for…

    Torsten S. -

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Vic Rebernigg

Mitglied seit: 02/10/16

1 Reputation

0 Kommentare