Einleitung
In the situation that your Sony BDP-BX510 disk tray is not opening despite trying the solutions on the troubleshooting page, you may need to replace it . This guide will provide you with the steps required to safely remove your disk tray for replacement. The tools that are needed include a Phillips #2 screwdriver and tweezers.
Werkzeuge
-
-
To remove the tray cover, hold both sides of the tray cover and gently apply a downward pressure.
-
Apply slightly more pressure to the left side until it unhooks then unhook the right side.
-
Close the disk tray by pressing the eject button again, then power off the device and unplug it.
-
-
-
Turn to the back of the device.
-
Remove the two 7mm Phillips #2 screws.
-
Slide the two plastic covers on both sides of the device towards the back of the device to remove them.
-
-
-
Turn the device so you can see the bottom.
-
Unclip the three black plastic clips on the bottom of the device.
-
Unclip one clip on each side of the device.
-
-
-
Pull the medium-sized 9 pin ribbon cable and the small 5 pin ribbon cable out of their connector in the motherboard.
-
Using tweezers, lift the black tab on the connector of the large 45 pin connector on the motherboard.
-
Pull the large 45 pin ribbon cable out of the connector in the motherboard.
-
-
-
Remove the 5mm Phillips #2 screw holding the metal brace above the disk tray.
-
Remove the two 5mm Phillips #2 screws that hold the disk tray to the metal case on the bottom.
-
-
-
Turn the device over to the backside.
-
Use tweezers or hands to take off the metal clasp for the metal brace near the center on the bottom of the device.
-
To reassemble your device, follow these instructions in reverse order.
