Sony Cyber-Shot DSC-W830 Front and Back Panel Replacement

Geschrieben von: Tong Tang
  • Kommentare: 1
Sony Cyber-Shot DSC-W830 Front and Back Panel Replacement

Schwierigkeitsgrad

Moderate

Schritte

6

Zeitaufwand

3 Minuten

Einleitung

If you have broken the outer panels of your DSC-W830, do not worry. This guide will take you through the correct steps of remove both the front and back panels.

  1. aCHlYPSvgMDQCLkf

    • Slide the lock at the bottom of the camera to "Open".

    • The door to the battery pack is spring loaded.

  2. bAHDegt2FbfbXXst

    • Slide the blue clip up and away from the battery.

  3. QUSyALrrQLSeYyiu

    • Remove the battery.

  4. a5W6aJvOcVUlq4Uj
    a5W6aJvOcVUlq4Uj
    NdlleuqqdYLJBFfH
    Xk1fJoeEx6d5dicn

    • Remove the six 3.5mm Phillips #000 screws.

    • Rotate the lock away from the camera.

  5. Pi1XMSPbeBTymXOi
    Pi1XMSPbeBTymXOi
    2pGtYkfvDJTyyuhY
    eIrRwSaLELKZLFyC

    • Pry the device open with the plastic opening tool.

    • There are two clips that help prevent the front panel from separating.

    There is also a small corner piece, coloured the same as camera body, at the battery compartment corner which will also fall out. be careful not to loose it - it’s a bit fidly to fit back when re-assembling, but logcal. The Ifixit tweezers where a great help in locating it back on its pins.

    Nicholas Smith -

  6. IGTJ1NvD2oZPIfCj
    IGTJ1NvD2oZPIfCj
    ljUrg3amZdXmAZ5w
    SJ2MRWXlQeTPRVrW

    • Remove the two plastic spacers between the front and the back panels.

    • The spacers may fall out when removing the panels.

    • Carefully remove the back panel.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Tong Tang

Mitglied seit: 15/09/16

536 Reputation

0 Kommentare