Einleitung
Repairing/replacing the DVD drive.
Werkzeuge
- 
                  
                  
- 
            
Turn the laptop upside down so that the top is sitting on a flat surface.
 - 
            
If you are looking at the bottom of the laptop the battery is located on the front right side of the laptop; the opposite side from the floppy disk drive.
 
 - 
            
 - 
                  
                  
- 
            
As shown by the arrow, slide the plastic cover up and then pull out and downwards.
 - 
            
You should now be able to pull the battery out.
 
 - 
            
 - 
                  
                  
- 
            
Remove the four 16 mm screws bordering the edge of the laptop using a Phillips #0 screwdriver.
 
 - 
            
 - 
                  
                  
- 
            
Remove the 4mm screw on the right rear side of the laptop next to the audio ports using a Phillips #0 screwdriver.
 
 - 
            
 - 
                  
                  
- 
            
Slide the blue speaker grille (located above the keyboard) to the right and gently pull upward. The grille will still be connected by a white electrical strip.
 - 
            
Carefully pull out the white electrical strip. By doing this you will remove the speaker grille.
 
 - 
            
 - 
                  
                  
- 
            
Remove the 4mm screw in the center using a Phillips screwdriver.
 - 
            
Carefully and slowly pull the green strip straight up (away from the laptop) to disconnect it. Make sure not to pull too hard to avoid breaking.
 - 
            
The keyboard can now be removed.
 
 - 
            
 - 
                  
                  
- 
            
Remove the 4mm Phillips screw that connects the hard drive cage to the DVD drive.
 - 
            
Carefully remove the copper wire strip.
 
 - 
            
 
To reassemble your device, follow these instructions in reverse order.