Einleitung

  1. 23rS6FKpfdyvDHEh
    • Flip the computer so that the bottom is facing up.

    • Look to the long edge where the computer screen is hinged and find the "release slide". It is located at the top left corner of the square indent.

  2. UHcvjjXvA4fRg2SB
    • Use your finger to slide the release to the left.

  3. WxiVJRnMXlUGkJWF
    WxiVJRnMXlUGkJWF
    IXXsR44gQqrv315d
    • While holding the release slide with one hand, use your opposite hand to pull the battery from its slot by gently shaking the battery left and right to help slide it out.

    Digan me algo esta compu a parte de la batería que muestran ella trae alguna pila redonda pregunto porque tengo un problema con los BIOS y veo que es la única forma de recuperarla

    Pedro Molina -

  4. V4nGGYeH2tjt5sKn
    • Take out the screw in the center of the computer.

  5. gHTX4wh2I1uXmvtG
    • Flip the computer right side up.

    • Open screen so that keyboard is visible.

  6. JR1XesomruiNLKm1
    JR1XesomruiNLKm1
    KXkifWUdrpCgIfvk
    • Use a plastic opening tool to gently lift the keyboard at a corner.

    • Make sure you get below the keyboard itself and not just the keys.

    • Slide the tool around the perimeter of the keyboard and it will start to lift.

  7. AoDtPA6SSXXyMwyH
    AoDtPA6SSXXyMwyH
    YWcYaNCFjG3qNF4R
    • Do not pull the keyboard away from the computer. There is a ribbon cord attaching the keyboard to the computer.

    • Once the keyboard has been lifted at a few edges, lift the keyboard with both hands.

  8. OB5yLHhWOKX6rKMu
    OB5yLHhWOKX6rKMu
    bGBE3eHCBjPbLRA2
    DtWsm4GEE1IKbYvM
    • Locate the ribbon cord behind the keyboard.

    • Locate a brown clamp attaching the keyboard to the computer.

    • Use a plastic opening tool to lift the clamp and release the cable.

    • Now the keyboard can be pulled away entirely.

  9. UixTDngFyKgPW6Gd
    • Take out the screw under the keyboard.

  10. jojaXbQ5hEdreCWQ
    • Flip computer over and remove the 6 screws.

  11. uMwieeQYx2vBLOPi
    • Flip computer over again and unclip the plastic cover.

    • Do not be afraid to be rough, since the cover is hard to remove.

    • Be sure to remove the case slowly and unclip any ribbon cords that are attached.

  12. ufumhn3dVNVr1GRA
    ufumhn3dVNVr1GRA
    oCDRLEaN3CQrYZPq
    • Locate the hard drive disk. The hard drive disk will be covered by a shiny lid.

    • Unscrew the lid with a #00 Phillips Head Screwdriver.

    • There are 3 screws holding it in.

    • Grab the lid by one corner and pull off the lid.

  13. XgYuFMeVZdBJbcVE
    • Find the brown clip attached to the hard disk drive on the side facing the optical disk drive.

    • Carefully pull out the brown clip with your fingers.

  14. 3vyHB5mwxEdEbHIW
    • Hold the hard disk drive on the side where the brown clip was attached and lift it upwards to pull it out.

  15. MPwaHwNWgFtHO1SD
    MPwaHwNWgFtHO1SD
    XiIhhrLsMfEXAN3i
    lQITCi2Mb3BEgVPy
    • Remove the 3 indicated screws.

    • There are two small scews arounds the edge and one is on top of the optical drive.

  16. McvRdWAGyEnaP1jF
    McvRdWAGyEnaP1jF
    ik5fKTDO5HErLaFC
    • Remove the optical drive from resting positions.

    • Gently remove cord.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Luke Thornley

Mitglied seit: 03/04/12

87 Reputation

0 Kommentare