Einleitung

This repair guide will help you install a new USB cable for your car unit. It will ultimately enhance your experience while connecting the device to your car. This process requires you having a tool kit, specifically, the PH#0 screwdriver and a spudger. With that said, you should be good to go!

  1. xsmMKycf52xfUZOH
    xsmMKycf52xfUZOH
    dFGauf4WlttbqBPF
    CUFGa2VZkGe2TW5Q
    • Place the device on a flat surface, upside down, so the bottom of the screen would be facing upwards.

    • Remove the ten 3.5mm Phillips #0 screws from the back plate.

  2. B2GFcRl3GaI5a3Yk
    B2GFcRl3GaI5a3Yk
    bL2CJSZAlKgp4Rxb
    • Use a plastic opening tool to remove the back plate.

    • Don't remove completely as there will still be cables connected.

  3. 5RPDNuHstMwktSKN
    • Disconnect the USB cable from the display board.

  4. qaPKP6hHdmZvxAdK
    • Adjust the rubber holders that are keeping the USB cable still on the motherboard, so you can remove the cable entirely from the inner compartment.

    • The rubber holders are extremely sensitive to any applied force. Therefore, be careful while turning them around.

  5. r4JkgkMCpNMhhKS2
    r4JkgkMCpNMhhKS2
    AdvJpMRSHQSQhURQ
    ZrPvVqJlJM5wgwC1
    • Remove the 3.5mm Phillip #0 screw that secures the USB cable to the back panel.

    • Pull the USB cable off of the back plate.

    Our radio is not interfacing with my phone it says USB connection problem before I tear it all apart what else could it be thank you

    Don Bartolotta -

Abschluss

To reassemble your device, follow these instructions in reverse order.

Abdulaziz Redha

Mitglied seit: 23/02/18

741 Reputation

3 Kommentare

Where i can get replacement lead?

mudylla -

where can i get a replacement lead for this please

Andy 777 -

im in the UK

Andy 777 -