Sphero Ollie Motherboard Replacement

Geschrieben von: Krystal Hedrick
  • Kommentare: 0
Sphero Ollie Motherboard Replacement

Schwierigkeitsgrad

Easy

Schritte

5

Zeitaufwand

15 Minuten

Einleitung

This guide will illustrate how to easily replace the motherboard on the Sphero Ollie with only your hands, Plastic Opening Tool and a Phillips-Head Screwdriver.

  1. 3tVghL2xR1ythUXp

    • Firmly grasp Ollie in one hand.

    • Remove the blue rubber tire in a peeling motion with your opposite hand.

  2. id5onNqgvpMfTvCN
    id5onNqgvpMfTvCN
    aCit24D3glgcfA3X

    • Continue to firmly hold Ollie in one hand.

    • Use a Plastic Opening Tool to gently pry off the hubcap.

    • Avoid inserting the Plastic Opening Tool into the empty holes, but instead use the tool near the tabs holding the hubcap in.

    • Do not aim the hubcap towards another person as it may pop off with force.

  3. rGZkdMOqixXtcHfV

    • Loosen and remove the 10mm screw on each side of the device using a JIS 1 screwdriver tip.

    • Remove the plastic tire frame from the device

  4. mdenwShUXTFkpJKj
    mdenwShUXTFkpJKj
    wJRR4wSJGrWPYD3Y

    • Loosen and remove the four 10mm Screws on the underside of the device using a JIS 1 tip.

    • Firmly grasp the bottom of the device and pull the top half of the outer case off of the bottom.

  5. iEEvL6LJBOTaRjIW
    iEEvL6LJBOTaRjIW
    12odW6mnxlIQofTW

    • Loosen and remove the 10mm screws holding the blue tooth connector as well as the two 1 10 screws holding the motherboard to the case using the JIS #1 screwdriver

    • Loosen and remove the 10mm screws holding the antenna to the case.

    • Gently remove mother board from the case with an upward motion.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Krystal Hedrick

Mitglied seit: 30/10/17

352 Reputation

0 Kommentare