Spin Master Hatchimal Draggle Fur Replacement

lay the Hatchimal on its side.

Using the plastic opening tool, push in on the purple clip.

Pull the wing off of the hatchimal.

Cut the fur retaining zip-tie with a pair of scissors.

Lift the fur up until it can't go further.

Use the spudger tool to push up on the black clip to free it.

Pull the clip out.

Lift fur up to reveal the next set of clips.

Insert a spudger to push up on the black clip to free it.

Pull out the clip.

Lift the fur up and over the Hatchimals Head.

Remove the six 12mm Phillips #00 screws from then body.

Pull the casing apart.

Remove the yellow speaker cable.

Remove the three 7mm Phillips #00 screws from the head.

Remove the wheel base and the circuit board carefully not to damage the spring.

Push the six black fur clips out using the spudger.

Remove the fur completely.