Einleitung

Use this guide to remove the thumbsticks in your SteelSeries Stratus Duo controller.

  1. DEitlsRW1ZEqvXAX
    DEitlsRW1ZEqvXAX
    GPL1htALS3WrfPrI
    • Use your fingers to remove the sticker located on the back cover of the Stratus Duo.

    • If you have trouble removing the sticker, heat an iOpener and apply it to the rear case for two minutes to loosen the adhesive underneath. You can also use a hair dryer to soften the adhesive.

  2. yYOv3pVcAAsfITRv
    • Use a Y0 Tri-point screwdriver to remove the five 9.3 mm-long screws securing the back cover.

  3. vgAv6AWkhn31BpC1
    vgAv6AWkhn31BpC1
    U1yyKvYwWhOEoWZC
    mA56JBnMSefWUs4P
    • Don't try to remove the back cover assembly all the way yet, as it's still connected to the mainboard.

    • Carefully lift the back cover assembly away from the frame and move it downward to uncover the battery cable and the interconnect cable at the top of the motherboard.

  4. GSD1uHYYKShBmRlR
    GSD1uHYYKShBmRlR
    lVDZNWf1mhSt2Njh
    vHxWAhPsBvQFUd1V
    • Using the pointed end of a spudger, push the grey tabs on the interconnect socket away from the socket, parallel to the interconnect cable, to release the cable.

  5. dtuKMIvfjIcxhMBX
    dtuKMIvfjIcxhMBX
    BNvarcllVYDdhSPA
    • Use a pair of blunt nosed tweezers or your fingers to pull the cable out of the socket.

  6. xaAmxStDcpSal3QY
    xaAmxStDcpSal3QY
    DjAiPhOlMahXRZFv
    ElJWZvtglfmQYKKw
    • Use a pair of blunt nose tweezers to grab and lift the connector away from the motherboard.

  7. ahHyoQQroZHZSjjU
    • Remove the back cover assembly.

  8. Q6TiWLVqrIZP1ujF
    • Use a Phillips screwdriver to remove the two 6.8 mm-long screws securing the thumbsticks board.

  9. ahIGKqMrH1qcSBqn
    ahIGKqMrH1qcSBqn
    3BWtS5qciJeBwMr5
    ZRpiYXgjfDJFJRAZ
    • Grab the thumbsticks board with your hand and disconnect it by pulling it straight up and out of its socket on the mainboard.

    • Remove the thumbsticks board.

    • For reassembly make sure to correctly align the ten pins with their socket on the mainboard.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Take your e-waste to an R2 or e-Stewards certified recycler.

Repair didn’t go as planned? Check our Answers community for help.

Adriana Zwink

Mitglied seit: 18/12/19

38806 Reputation

Ein Kommentar

where do i buy the thumbsticks board

Juan Ureña -